登录
首页 » matlab » reliability-simulink-

reliability-simulink-

于 2011-03-22 发布 文件大小:24KB
0 195
下载积分: 1 下载次数: 1

代码说明:

说明:  关于飞机控制系统的可靠性仿真,很好的一篇论文(reliability simulink of aircraft environment control system)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • ThinPlateSpline_MatlabCode
    薄板样条图像变换方法,MATLAB程序,根据控制点变化平滑地变形图像,experiment.m为例子(Thin plate spline image transformation method, MATLAB program, based on the control points change smoothly deformed image, experiment.m for example)
    2014-09-28 20:29:02下载
    积分:1
  • DSPII_USTC_01
    传统的宽带信号中抑制正弦干扰的方法是采用陷波器(notch filter),为此需要精确知道干扰正弦的频率.然而当干扰正弦频率是缓慢变化时,且选频率特性要求十分尖锐时,则最好采用自适应噪声抵消的方法.下图是用一个二阶FIR的LMS自适应滤波器消除正弦干扰的一个方案。该代码实现了以下功能: 1) 借助MATLAB画出了滤波器的误差性能曲面和误差性能曲面的等值曲线; 2) 给出了最陡下降法以及LMS算法的计算公式; 3) 用MATLAB产生了方差为0.05, 均值为0白噪音S(n),并画出某次采样得到的波形; 4) 根据 2)中的公式,并利用 3)中产生的S(n),在 1)中的误差性能曲面的等值曲线上叠加画出了采用最陡下降法以及LMS法时H(n)的在叠代过程中的轨迹曲线; 5)用MATLAB计算并画出了LMS法时误差随时间n的变化曲线(对应S(n)的某一次的一次实现)和e(n)波形; 6)在 1)中的误差性能曲面的等值曲线上,叠加画出采用LMS法得到的100次实验中的H(n)的平均值的轨迹曲线; 7)最终对结果进行了分析,具体见压缩包的word文档。 (Wideband signal in the conventional sinusoidal interference suppression method is the use notch filter (notch filter), this requires precise knowledge of the frequency of a sinusoidal interference . However, when the interference frequency sinusoidal changes slowly , and the selected frequency characteristic requirements are very sharp , then best use of adaptive noise cancellation method . following figure is a second-order FIR LMS adaptive filter to eliminate a program sinusoidal interference . The code implements the following functions:   A ) draw with MATLAB error performance of the filter surface and the surface contour error performance curve 2 ) gives the steepest descent method and the LMS algorithm formula 3 ) generated using MATLAB variance of 0.05 with a mean of 0 white noise S (n), and draw a particular sampling waveform 4 ) based on 2 ) of the formula , and use 3 ) generated in S (n), in a ) the error performance curves superimposed on the surface contour pl)
    2013-11-06 13:12:36下载
    积分:1
  • Find-Fourier-Series-Approximation
    求解锯齿信号的Fourier级数 利用了Fourier变换(Find Fourier Series Approximation The FFT is used. Choose sufficient harmonics to minimize aliasing)
    2010-08-01 23:49:09下载
    积分:1
  • suanfa
    10个基本阵列,方向60 ,80,85,120,130 通用INR=5dB,用music,capon,线性预测,波束形成等四种算法画出功率谱图。(10 basic arrays, direction 60, 80,85,120,130 common INR = 5dB, with music, capon, linear prediction, beamforming and other four algorithms to draw power spectrum.)
    2011-08-03 22:52:04下载
    积分:1
  • viterbisim
    Computer vision experiments 4- to step in the preparation of cany use of edge detection operator used to compare the Matlab
    2014-11-26 17:20:24下载
    积分:1
  • 建模文献
    分析橡胶挤出到人工分剪过程中的运动,以适应企业所生产所有规格橡胶为目标;以台达SV2型号PLC为控制核心,采用惠斯通电桥压电式传感器实时采集橡胶重量变化;针对现场加工环境中产生的振动干扰,并分析称重传感器采集到的称重信号;针对分剪系统响应速度与橡胶挤出速度匹配问题导致的不同挤出速度下误差的分布不同,且随着挤出速度的增大导致所分剪橡胶误差也增大的问题,(The movement of rubber extrusion to artificial shearing process is analyzed in order to adapt to the rubber of all specifications produced by the enterprise. Taking the delta SV2 model PLC as the control core and using the Wheatstone bridge piezoelectric sensor to collect the change of rubber weight in real time, the vibration interference produced in the field processing environment and the analysis of the weighing sensor are analyzed. The set of weighing signals; the distribution of errors at different extrusion speeds caused by the matching of the response speed of the shear system to the rubber extrusion speed is different, and the error of the shear rubber increases with the increase of the extrusion speed.)
    2018-04-19 21:49:52下载
    积分:1
  • work
    二进制小数的除法计算,三个matlab代码(Calculation of the binary decimal division)
    2010-02-27 17:00:45下载
    积分:1
  • PEG
    用PEG构造法生成LDPC监督矩阵的程序(With PEG construction method to generate LDPC matrix program oversight)
    2011-09-02 22:39:32下载
    积分:1
  • MATLAB
    matlab入门教材,讲解的内容比较基础,适合初学者学习(matlab introductory textbook to explain the contents of the basis for comparison, suitable for beginners to learn)
    2013-03-23 17:22:12下载
    积分:1
  • Experimental_Course_MATLAB_new
    MATLAB新版实验教程Experimental Course MATLAB new(MATLAB new experimental tutorial Experimental Course MATLAB new)
    2010-08-08 21:16:35下载
    积分:1
  • 696518资源总数
  • 106155会员总数
  • 8今日下载