-
Bpnet
BP网络的MATLAB工具箱的实现。。 ——Bpnet(BP network MATLAB toolbox implementation. .- Bpnet)
- 2009-12-11 21:36:38下载
- 积分：1
-
LinearAlgebra
Elementary Linear Algebra
- 2010-03-04 07:03:27下载
- 积分：1
-
NUMERICALANALYSIS
some code for numerical analysis.The main goal is to provide insight into numerical analysis rather than merely to provide numerical recipes.
- 2010-05-13 22:38:33下载
- 积分：1
-
LTE_channelestimator_MSE
最小均方误差的信道估计程序,对学习LTE很有帮助(LTE_channelestimator_MSE Minimum mean square error of channel estimation procedures
)
- 2013-11-21 19:14:34下载
- 积分：1
-
read_grib2
用来处理气象上NCEP资料grib2的matlab处理程序(Matlab Processing Program for Processing NCEP Data grib2 in Meteorology)
- 2020-06-15 22:25:02下载
- 积分：1
-
ofdmweb2
对于OFDM系统在三种信道模型下进行了仿真，给出了误码率分析并绘图给出了结果(For OFDM system in the three channel model simulation under the given bit error rate analysis and mapping results are given)
- 2009-05-29 11:51:37下载
- 积分：1
-
somtoolbox
自组织特征映射神经网络是一类无导师学习的神经网络模型可用于聚类分析(Self-organizing neural network is a kind of unsupervised learning neural network model can be used for cluster analysis)
- 2015-01-23 17:00:42下载
- 积分：1
-
adc_dynamic_testing
ADC动态参数测试的matlab程序，可以测试DNL，INL，ENOB，SFDR等(ADC dynamic parameter test matlab program, you can test DNL, INL, ENOB, SFDR, etc.)
- 2021-02-20 21:29:43下载
- 积分：1
-
leachimprove
无线传感器网络leach协议，在matlab上的改进算法，考虑了能量(Leach protocol of wireless sensor networks, the improved algorithm in matlab, taking into account energy)
- 2012-03-28 13:12:55下载
- 积分：1
-
ICEE-574
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:54:09下载
- 积分：1
