-
examples
8279显示接口,废话太多不好谁说一定要二十个字才行啊发送方跌幅较深的仿佛就是放假反倒是开飞机两个ij(just a text 。You needn’t have come over yourself.
As it turned out to be a small house party, we so formally.
[A] needn’t dress up [B]did not need have dressed up
[C] did not need dress up [D] needn’t have dressed up
)
- 2010-09-18 09:50:22下载
- 积分：1
-
matlabfitellipsecode
说明： 对离散数据运用最小二乘法进行椭圆拟合，运行过了觉得还不错就上传了。(Discrete data on the use of least squares method for ellipse fitting, run over a feel good on the uploaded.)
- 2008-12-05 11:12:05下载
- 积分：1
-
load-prediction
根据给定的每15min预测一次的负荷数据，利用灰色预测GM（1,1）理论进行预测，并分别预测一周内周末和工作日的负荷变化情况，最终形成负荷变化曲线(According to the given load once every 15min forecast data, the gray prediction GM (1,1) theory to predict, and are predicted load changes within a week on weekends and weekdays, eventually forming the load curve)
- 2021-03-21 16:59:17下载
- 积分：1
-
InversePerspectiveMapping
说明： 逆透視轉換Matlab程式，可降透視轉為鳥瞰(Inverse Perspective convert Matlab program can be reduced to a bird)
- 2008-08-27 23:08:20下载
- 积分：1
-
ECG-Matlab
ECG Matlab仿真,:ECG心电信号matlab仿真画图,其中包括P波、Q波、QRS波、S波、T波和U波(ECG Matlab)
- 2020-11-18 17:39:38下载
- 积分：1
-
压缩感知程序源码 BCS
压缩感知程序源码，Blind compressed sensing (BCS)不需要在采样和恢复阶段预先知道稀疏基。源码对于研究压缩感知前沿具有很好的借鉴意义。(The fundamental principle underlying compressed sensing is that a signal, which is sparse under some basis representation, can be recovered from a small number of linear measurements. However, prior knowledge of the sparsity basis is essential for the recovery process. Blind compressed sensing (BCS) avoids the need to know the sparsity basis in both the sampling and the recovery process. That is, BCS aims at recovering an ensemble of vectors, all sparse under the same unknown basis, given small number of linear measurements of these vectors.
)
- 2020-06-29 05:40:01下载
- 积分：1
-
基于有限差分法的二维边值问题的数值分析
1. 在matlab中分析基于分离变量法的解析解；
2. 利用简单迭代法求解，与解析法结论对比，分析求解结果的精确度。分析过程至少包括：在网格尺寸为0.1 m和1 m两种条件下，两次迭代差值最大为10-10时的分析结论；
3. 利用超松弛迭代法分析，选择松弛因子，分析其对收敛速度（即迭代次数）的影响，并确定最优值。分析过程至少包括：在网格尺寸为0.1和1两种条件下，两次迭代差值最大为10-10时，迭代次数随松弛因子的变化，得到对应的最优松弛因子，与经验值（课本165页式子3.7.15）进行对比。(1. Analyze the analytical solution based on the separation variable method in matlab.
2. Using a simple iterative method to solve, compared with the results of the analytical method to analyze the accuracy of the solution. The analysis process at least includes the following conclusions: when the mesh size is 0.1m and 1m, the maximum difference between two iterations is 10-10.
3. Analyze using the relaxation relaxation iteration method, select the relaxation factor, analyze its influence on the convergence speed (ie the number of iterations), and determine the optimal value. The analysis process at least includes the following: when the mesh size is 0.1 and 1 and the maximum difference between two iterations is 10-10, the number of iterations varies with the relaxation factor, and the corresponding optimal relaxation factor and empirical value are obtained ( Textbook 165 pages (3.7.15) for comparison.)
- 2020-07-28 18:48:39下载
- 积分：1
-
dm_knn_wenyin4
this is the implementation of introduced algorithm(feature selection algorithm for mixed data with both nominal and continuous features,Wenyin Tang & K.Z. Mao)
- 2010-05-10 11:23:15下载
- 积分：1
-
AF-MATLAB
放大转发中继通信，理论误码率，蒙特卡洛误码率，直传误码率仿真，信道容量，中断概率，功率分配仿真(Enlarge forwarding relay communication, error rate theory, Monte Carlo error rate, BER simulation forward pass, channel capacity, outage probability, power distribution simulation)
- 2021-02-10 21:39:52下载
- 积分：1
-
ExtKalman
This Embedded MATLAB Function implements an extended Kalman filter used
to estimate the states, road surface and mass of a quarter car model.
- 2016-01-20 22:13:14下载
- 积分：1
