-
1
说明： 进行最优化搜索中的牛顿法以及最速下降法运算，可根据已知函数以及初始点位置查到最优点(Optimized search of the Newton method and steepest descent method operation, according to the initial position of known function, and found the benefits of)
- 2011-01-16 17:46:56下载
- 积分：1
-
newton
Power flow studies, commonly known as load flow, form an important part of power system
analysis. They are necessary for planning, economic scheduling and control of an existing system as
well as planning its future expansion. The problem consists of determining the magnitudes and phase
angle of voltages at each bus and active and reactive power flow in each line.
In solving power flow problem, the system is assumed to be operating under balanced
conditions and a single-phase model is used. Four quantities are assumed at each bus. These are voltage magnitude v, phase angle , real power P, and reactive power Q.The Newton Raphson method of load flow analysis is an iterative method which approximates the set of non-linear simultaneous equations to a set of linear simultaneous equations using Taylor’s series expansion and the terms are limited to first order approximation.
- 2013-04-09 14:49:06下载
- 积分：1
-
label_wy
说明： 在matlab环境下，对图像中的单个目标进行标号(In the matlab environment, the image of a single target labeling)
- 2008-10-29 00:40:34下载
- 积分：1
-
fcoding
时间发生时间频域编码与地形图显示时间发生时间频域编码与地形图显示(Frequency domain code)
- 2012-04-10 16:49:31下载
- 积分：1
-
Sim_MADA
A NEW MATLAB APPLICATION OF FEILD ORIENTED CONTROL (FOC) PROCEDURE TO DOUBLE FEED INDUCTION MACHINE.
- 2011-09-28 01:14:25下载
- 积分：1
-
svr_trainer
function approximation using SVR
- 2014-11-21 19:41:32下载
- 积分：1
-
use-OFDM--for-doppler
采用OFDM的数据符号去估计多普勒频率，从而估计出移动台的速度(Data using OFDM symbols to estimate the Doppler frequency, thereby to estimate the speed of the mobile station)
- 2020-11-18 10:29:39下载
- 积分：1
-
ComplexExponentialMethod
Complex Exponential Method for extracting modal properties of a structure.
- 2013-12-03 08:31:25下载
- 积分：1
-
M_sequence
使用移位寄存的方法产生M序列，在MATLAB编程中使用(The use of storage methods shift M sequence, the use of programming in MATLAB)
- 2009-05-01 14:05:42下载
- 积分：1
-
MIMO
MIMO系统容量仿真程序分为两个。其中
文件夹1为：发射天线数为4，接收天线数逐渐增大时MIMO系统容量的仿真程序。
文件夹2为：接收天线数为4，发射天线数逐渐增大时MIMO系统容量的仿真程序。(MIMO system capacity simulation program is divided into two. One folder 1 as follows: the number of transmitting antennas is 4, gradually increasing the number of receive antenna MIMO system capacity when the simulation program. Folder 2 as follows: the number of receiving antennas 4, gradually increasing the number of transmission antennas, MIMO system capacity when the simulation program.)
- 2021-02-23 22:59:40下载
- 积分：1
