-
RDA
实现合成孔径雷达点目标信号生成，使用RDA算法对点目标成像(Synthetic Aperture Radar points to achieve the target signal generation, the use of RDA algorithm for point target imaging)
- 2011-10-29 19:47:01下载
- 积分：1
-
ORDER
数组变换！逆序，将数组倒置！将一个二维数组行和列元素互换后到另一个二维数组中(Array transformation ! Reverse , the array upside down ! Will be a two-dimensional array of rows and columns after the swap element into another two-dimensional array)
- 2013-11-19 14:32:21下载
- 积分：1
-
MATLABsuanfa_30
MATLAB智能算法案例分析+源代码，共30个，可以满足一些常用的需求，供大家学习与交流(MATLAB intelligent algorithm Case+ source code, a total of 30, to meet the demand for them to learn and exchange)
- 2012-11-18 09:46:31下载
- 积分：1
-
OFDMqpsk
简单的OFDM仿真，采用QPSK调制，有串并转换，保护间隔，fft/ifft等(Simple OFDM simulation using QPSK modulation, there are serial to parallel conversion, guard interval, fft/ifft etc.)
- 2020-07-03 00:00:01下载
- 积分：1
-
2 1
说明： 假定导引头工作在理想状态，能够无延迟无误差地输出与视线角速度成比例的信号u，在此情况下的导引律(Assuming that the seeker works in an ideal state, it can output the signal U proportional to the angular velocity of the line of sight without delay and error. In this case, the guidance law)
- 2019-07-29 14:32:54下载
- 积分：1
-
EEG_Enhancer
A EEG Enhancer with kalman filter enhancer
- 2010-09-04 13:58:29下载
- 积分：1
-
IffiinchartB
IBMde股票图形示例，，含数据有布林线，平均移动线
(IBMde stock graphic example, with data Bollinger Bands, Moving Average Line)
- 2012-07-29 00:35:04下载
- 积分：1
-
adaboost1
adaboost代码，比较简单。但方便了解Adaboost算法的基本原理(The aim of the project is to provide a source of the
meta-learning algorithm known as AdaBoost to improve
the performance of the user-defined classifiers.
)
- 2013-08-24 11:12:16下载
- 积分：1
-
k-means算法的Matlab实现以及Iris数据集
k-means算法实现以及Iris数据集(Implementation of K-means algorithm and Iris data set)
- 2020-12-18 16:29:10下载
- 积分：1
-
re1
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:51:25下载
- 积分：1
