登录
首页 » matlab » RLS

RLS

于 2011-05-01 发布 文件大小:4KB
0 276
下载积分: 1 下载次数: 9

代码说明:

  rls自适应算法,以仿真过,可供大家参考(rls adaptive algorithm, to simulate too, for your reference)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • demo-matlab
    说明:  在matlab中剪切出自己感兴趣的区域,鼠标点出两点,即可裁剪出所需矩形。(Cut in matlab in their own areas of interest, the mouse to point out two things, you can cut the required rectangle.)
    2011-04-07 11:50:08下载
    积分:1
  • FHSS_DSSS_CDMA
    FHSS_DSSS_CDMA的m文件,可以在matlab的simulink上仿真~(FHSS_DSSS_CDMA the m file )
    2012-05-12 09:56:36下载
    积分:1
  • BMDCP
    水文趋势、突变点分析的matlab相关程序——水文时间序列变点分析的贝叶斯方法(Hydrological trends point mutation analysis matlab procedures- hydrological time series change point analysis, Bayesian methods)
    2020-11-27 02:29:31下载
    积分:1
  • Flow-calculation
    简单经典的潮流计算程序 适合初学者理清潮流计算的编程思路(Simple classic flow calculation procedures, suitable for beginners to sort out programming ideas flow calculation)
    2013-08-22 22:03:14下载
    积分:1
  • prog.m
    k nearest neighbor algorithm for matlab
    2013-04-09 01:34:55下载
    积分:1
  • matlab
    1. 给一段原始的语音信号(可以是自己录制的一段语音),加上一频率为3.8kHz的高频余弦噪声和频率为3.6kHz的高频正弦噪声(幅度自己可以选择),用窗函数设计一滤波器(要求最小阻带衰减为50dB)对加噪后的语音信号进行滤波,画出滤波器的频率响应曲线,画出滤波前后的时域图和频谱图。 需要用到的函数: fir1 用窗函数设计FIR滤波器的函数 2. 用GUI设计一界面(如图1所示)完成如下功能: 1) 输入一语音信号,画出语音信号的时域图和频谱图; 2) 对语音信号加噪处理,画出加噪后的时域图和频谱图; 3) 给定滤波器的性能指标,采用几种不同的方法设计滤波器对加噪信后进行滤波,画出各滤波器的频率响应曲线,画出滤波后的时域图和频谱图。 (1. to some of the original speech signal (which can be a voice you record yourself), plus a cosine frequency of 3.8kHz frequency noise and frequency of 3.6kHz frequency sinusoidal noise (in the range that they can choose), with a window function to design a filter (requires a minimum stop band attenuation is 50dB) after adding noise to the speech signal is filtered, the filter frequency response curve to draw, draw diagrams and time-domain spectrum before and after filtering. Need to use the function: function fir1 with window function design FIR filter design 2. Using a GUI interface (Figure 1) complete the following functions: 1) an input speech signal, the speech signal in the time domain to draw graphs and spectrum 2) adding noise to the speech signal processing, draw diagrams and time-domain plus noise spectrum after 3) to set the filter performance, using several different methods designed to filter letter after adding noise filtering, draw the frequency response curve of each )
    2015-01-09 10:00:04下载
    积分:1
  • fig_3_wuganraojiachuanghou
    lfm 脉冲压缩雷达目标探测MATLAB仿真(lfm radar MATLAB)
    2020-07-26 14:38:42下载
    积分:1
  • zr
    说明:  用双线性变换法设计一个Butterworth低通滤波器,要求其通带截止频率100Hz,阻带截止频率200Hz,通带衰减小于2dB,阻带衰减大于15 dB,采样频率为500 Hz。(Using bilinear transformation to design a Butterworth low-pass filter, requiring that their pass-band cutoff frequency 100Hz, stopband cutoff frequency 200Hz, pass-band attenuation is less than 2dB, stop-band attenuation greater than 15 dB, a sampling frequency of 500 Hz.)
    2010-06-23 20:51:53下载
    积分:1
  • Speech_DTW
    this is a matlab code for computing DTW(dynamic time warping) for speech processing applications.
    2010-01-24 04:06:33下载
    积分:1
  • kalmanRA2
    针对噪声,用AR2建模,用卡尔曼滤波,并用Allan方差检验(against noise, using AR2 modeling, Kalman filtering, and with Allan variance test)
    2006-10-19 16:39:40下载
    积分:1
  • 696518资源总数
  • 106148会员总数
  • 10今日下载