登录
首页 » matlab » scottsclock2

scottsclock2

于 2011-05-02 发布 文件大小:3KB
0 249
下载积分: 1 下载次数: 8

代码说明:

  MATLAB开发的精美时钟2,界面美观漂亮.(MATLAB development of the fine clock 2, the interface is beautiful beautiful.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • bizhi
    基于FFT的比值算法,是用比值法实现的MATLAB程序。 (Based on the ratio of FFT algorithm, is the ratio method using the MATLAB program realize.)
    2007-08-28 10:35:37下载
    积分:1
  • hengjia
    计算一个平面桁架结构的总体刚度矩阵,最后以图形形式显示出桁架结构(Calculation of a plane truss structure' s overall stiffness matrix, the last show in graphical form of truss structure)
    2011-06-07 22:09:20下载
    积分:1
  • MexDemo
    使用vc6.0与matlab 2010b联合编程,并且测试通过 接口函数的编写(vc6.0 matlab 联合编程)
    2012-05-06 20:15:30下载
    积分:1
  • LPCC
    this is lpcc matlab code
    2013-09-19 05:38:12下载
    积分:1
  • boost
    BOOT PI CLOSE LOOP CONTOLLER
    2013-10-19 18:20:50下载
    积分:1
  • Optimalreceptionofadditivewhite
    本设计主要对4PSK调制方式的信号,利用MATLAB的m文件进行最佳接收机的设计与仿真。对输入的叠加噪声的4PSK调制信号进行接收,利用相关解调器来实现信号解调,及最大似然准则来实现检测器。在相关解调器中,接收信号分别与基函数 和 相乘再积分。在检测器中,利用相位来判断输出,从而最终得到接收的数据。采用随机二进制数通过4PSK调制后叠加高斯白噪声再对设计的接收机进行测试,从测试的结果可看出,在信噪比大于-8dB时,误码率为0,说明该接收机较好的实现了抗噪声性能。(The design of the main 4PSK modulation mode of the signal, the use of MATLAB m file for the best receiver design and simulation. The 4PSK modulated signal of the input superimposed noise is received, and the demodulator is realized by the relevant demodulator, and the maximum likelihood criterion is used to realize the detector. In the associated demodulator, the received signal is multiplied by the basis function and multiplied by the basis function. In the detector, the output is judged by the phase, and finally the received data is obtained. Using the random binary number through 4PSK modulation after the superposition of white noise and then the design of the receiver to test the test results can be seen in the signal to noise ratio greater than-8dB, the bit error rate is 0, indicating that the receiver is better The realization of the anti-noise performance.)
    2020-10-24 00:07:22下载
    积分:1
  • fastimagesegmentaionusingdelaunaymathworks
    this is a very good program of 3D-stereovision.
    2010-11-17 20:14:07下载
    积分:1
  • polarization-array-beamforming
    针对极化阵列的波束综合问题,并把这一问题描述成一个凸优化问题。 (For polarization array pattern synthesis problem, and describe it as a convex optimization problem.)
    2013-12-16 19:37:19下载
    积分:1
  • xiaobo
    局部放电试验所采集的信号中往往混有白噪声、周期干扰信号去除。此处采用常用db系列小波中的db6小波进行9尺度的多分辨分解后,根据白噪声能量特性,估算各尺度的阈值大小,采用硬值进行处理,后进行重构。(Partial discharge test of the signal collected is often mixed with white noise, periodic interference signal removal. Here the use of commonly used wavelet db Series DB6 wavelet carried out in the 9-scale multiresolution decomposition, based on the energy characteristics of white noise to estimate the scale threshold size, the use of hard-value deal, after the remodeling.)
    2020-12-25 20:29:04下载
    积分:1
  • DQ
    说明:  卫星天线升线,保证能看外国台,是我用了三个月的时间编写而成,是我们学习卫星天线设计的理想程序(Satellite antenna booster line, guaranteed to see a foreign station, I spent three months been prepared by the satellite antenna design is the ideal learning program)
    2010-10-06 20:50:01下载
    积分:1
  • 696516资源总数
  • 106913会员总数
  • 8今日下载