登录
首页 » Windows_Unix » CODE_PVC

CODE_PVC

于 2010-05-10 发布 文件大小:5KB
0 233
下载积分: 1 下载次数: 6

代码说明:

  [MATLAB] : solution of the pvc problem by genetic algorithms

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • GPS
    GPS信号处理流程,包括信号发生、接收机捕获、跟踪和定位解调。(GPS signal processing flow, including signal generator, receiver capture, tracking and positioning demodulation.)
    2021-04-23 21:48:47下载
    积分:1
  • fiusou_v49
    LCMV优化设计阵列处理信号,均值便宜跟踪的示例,小波包分析提取振动信号中的特征频率。( LCMV optimization design array signal processing, Example tracking mean cheap, Wavelet packet analysis to extract vibration signal characteristic frequency.)
    2016-07-25 15:32:34下载
    积分:1
  • wind_load
    船舶操纵运动仿真模型之风力模型研究(根据经验公式得出)(Research ship motion simulation model of the wind model manipulation (based on empirical formulas derived))
    2014-01-10 12:27:26下载
    积分:1
  • GAs
    遗传算法简明教程,附带程序,深入浅出讲解(Simple genetic algorithm tutorial, with procedures in layman' s language to explain)
    2010-07-21 16:34:53下载
    积分:1
  • 5.rar
    matlab的算法关于计算的一席人常用算法(matlab algorithm for computing a seat on one commonly used algorithm)
    2011-06-24 21:21:48下载
    积分:1
  • Obstacle-avoidance
    四个机器人,实现编队行走,遇到障碍物后变换队形,实现避障,基本思想是利用栅格法。(Four robot, achieve the formation of walking, encounter an obstacle after the formation and transformation, to achieve obstacle avoidance, the basic idea is using grid method.)
    2021-04-29 22:48:42下载
    积分:1
  • FH_chaos
    在matlab中实现关于logistic映射的混沌序列的仿真(the realise of chaos sequence in matlab)
    2021-04-15 03:18:55下载
    积分:1
  • visiblity
    Fast Visibility Restoration from a single Color or Gray level Image source code
    2010-07-24 15:40:22下载
    积分:1
  • trns
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:45:44下载
    积分:1
  • oqpsk的MATLAB
    说明:  熟悉OQPSK的基本原理、调制解调技术,掌握MATLAB中M文件的使用及相关函数的调用方法(The goal of this design is to deeply understand the basic principle of OQPSk modulation and demodulation, learn how to use MATLAB software in the M file to realize OQPSk modulation and demodulation analysis and join the influence of different noise on the signal, the first to create a digital baseband signal and then the corresponding function in MATLAB the baseband signal modulation, and then analyses the waveform of the modulated, record the results of modulated signals after demodulation, observe the demodulation results and record, finally adding noise in the signal and then observe the changes of the time-frequency diagram,)
    2020-04-08 10:21:18下载
    积分:1
  • 696516资源总数
  • 106627会员总数
  • 16今日下载