-
highf
高通滤波器，用于对信号中高频噪声的滤除
同时还包含哈弗曼编码的一些基本源程序(high pass filter)
- 2010-10-19 22:59:07下载
- 积分：1
-
x1
说明： 声音信号 显示 时域 频域 对声音的预处理观察
- 2009-05-25 13:14:22下载
- 积分：1
-
FSK
代码详细的书写了FSK的过程，其中分为相干与非相干两个部分。(Code written in detail the FSK process, which is divided into two parts coherent and incoherent.)
- 2015-05-20 15:41:39下载
- 积分：1
-
雷达信号处理基本流程
去斜处理（宽带的匹配滤波）Stretch方法是针对线性调频信号而提出的， 其方法是将输入信号与参考信号 （经适当延迟的本振信号， 延迟量通常由窄带信号测距结果估计出） 混频 ，则每一个散射点就对应一个混频后的单频分量，对混频输出的信号进行 DFT 处理 ，即可获得目标的距离像，对参考信号的要求是应具有与输入信号相同的调频斜率。(dechirp matched filter
Stretch method is proposed for linear frequency modulation signal. It mixes the input signal with the reference signal (local oscillator signal with appropriate delay, the delay is usually estimated from the result of narrowband signal ranging). Then each scattering point corresponds to a single frequency component after mixing, and DFT is performed on the mixed-frequency output signal. The range profile of the target can be obtained by processing, and the reference signal is required to have the same frequency modulation slope as the input signal.)
- 2018-10-31 20:07:27下载
- 积分：1
-
New
fingerprint feature extraction
- 2011-07-03 20:14:06下载
- 积分：1
-
wind
基于Matlab/simulink 的风速仿真模型 对4种风速进行simulink建模 风力发电系统中的风速仿真模型(Use Matlab/simulink simulation software to establish a mathematical model for the four parts of the wind speed.)
- 2021-01-26 09:48:42下载
- 积分：1
-
DSkuopin
直接序列扩频通信系统抗正弦干扰仿真代码(Direct sequence spread spectrum communication system simulation code anti-sinusoidal interference)
- 2014-12-25 15:50:42下载
- 积分：1
-
Genetic-algorithm
采用MATLAB编程，采用遗传算法求分段函数极值(Using MATLAB programming, using genetic algorithm for segmentation function extremum)
- 2013-11-12 17:19:10下载
- 积分：1
-
cjinghua
绝对是学习c的好东西 ，想学C的人看看就知道了(Is definitely a good thing to learn c)
- 2010-01-26 21:04:05下载
- 积分：1
-
work
1) 以身高为例，画出男女生身高的直方图并做对比；
2) 采用最大似然估计方法，求男女生身高以及体重分布的参数；
3) 采用贝叶斯估计方法，求男女生身高以及体重分布的参数（假定方差已知，作业请注明自己选定的一些参数情况）；
4) 采用最小错误率贝叶斯决策，画出类别判定的决策面。并判断某样本的身高体重分别为(160,45)时应该属于男生还是女生？为(178,70)时呢？(1) taking height as an example, draw the histogram of male and female students and compare them;
2) the maximum likelihood estimation method was used to calculate the height and weight distribution parameters of male and female students;
3) using Bayesian estimation method to find the parameters of height and weight distribution of male and female students (assuming the variance is known, please indicate some of the parameters selected by the job);
4) using the minimum error rate Bayes decision, draw the decision surface of category decision. And determine the height and weight of a sample respectively (160,45), should belong to the boys or girls? What about (178,70)?)
- 2020-10-07 09:47:37下载
- 积分：1
