-
matlabexample
源码，非常实用，里外都是经过上机调试的源码，可以直接使用！(Source, very useful, both inside and outside the machine through the source debugger, you can directly use!)
- 2008-08-04 17:35:19下载
- 积分：1
-
jiyuMATLABdetuxiangchuli
说明： 基于MATLAB实现各种图片的读取显示及滤波功能,已经编译成功(Achieve a variety of images based on MATLAB to read display and filtering has been successfully compiled)
- 2011-03-21 12:52:32下载
- 积分：1
-
2
说明： matlab入门资料 建模 优化 神经网络
- 2010-05-24 19:17:16下载
- 积分：1
-
three_dim_plot
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:56:06下载
- 积分：1
-
renjihudong
两个设备形成对射，当有人通过时，一台设备发出指令，控制别的设备。(Two devices formed on the radio, when someone passed a device to issue commands to control other devices.)
- 2013-12-17 14:31:32下载
- 积分：1
-
pso-5
经典粒子群算法的matlab实现代码。用函数进行测试实验，并给出算法寻优迭代的效果图(Classical PSO algorithm matlab. Experiments with test functions, and gives an iterative optimization algorithm renderings)
- 2014-02-18 16:21:54下载
- 积分：1
-
tfr
MATLAB 程式设计，MATLAB基本运算
MATLAB基本平面绘图
MATLAB基本立体绘图
(MATLAB programming, MATLAB basic computing basic plane MATLAB basic three-dimensional graphics MATLAB graphics)
- 2007-12-04 19:28:29下载
- 积分：1
-
delta-sigma
Delta-sigma toolbox for Matlab/simulink
- 2012-06-03 21:35:20下载
- 积分：1
-
ECG--QRS
以软件为主的方法实现QRS波的检测滤波之后的信号一般经过一些
变换以提高QRS波的份量，进而采用一系列阈值进行判别，这些阈值有固定
阈值法，也有可变阈值法。前者由于可能的干扰或高P、高T波的存在，若
其滤波后超过其阈值便会产生假阳性(FP，falsepositive)结果；另外，当心
律失常或QRS波幅度变小，阈值设置过高，会导致漏检产生假阴性(FN，
falsenegative)结果。由于固定阈值的这些缺点，有研究者提出了用可变阈
值检测，以提高检测的精确率，所采用的可变阈值包括幅度阈值、斜率阈值
和时间间隔阈值等。(Give priority to with software method for detecting QRS wave signal after some commonly after filtering
Amount of transformation in order to improve the QRS wave, then using a series of threshold to distinguish, the threshold value is fixed
Threshold value method and variable threshold value method. The former due to the possible interference or the existence of the high P and T waves, if
More than the threshold value is created after the filtering false positives (FP, falsepositive results In addition, be careful
Law of disorder or QRS wave amplitude decreases, threshold is set too high, can lead to leak to produce false negatives (FN,
Falsenegative) results. Due to these disadvantages of fixed threshold, some researchers have proposed using variable threshold
Value detection, in order to improve the precision of detection rate, adopted by the variable threshold including amplitude threshold, the slope threshold
And the time interval threshold, etc.)
- 2014-10-22 09:55:16下载
- 积分：1
-
FCM-using-MRF-code
implementation of Fuzzy C Means clustering with Markov Random Field
- 2021-03-02 22:19:33下载
- 积分：1
