登录
首页 » Others » TEQC

TEQC

于 2010-05-14 发布 文件大小:20KB
0 136
下载积分: 1 下载次数: 62

代码说明:

  本章首先介绍了TEQC软件的基本功能,包括格式转换、数据编辑、质量检查、单点定位。接着列出了一些TEQC软件的常用命令,并作了详细的注释(This chapter introduces the basic functions of TEQC software, including format conversion, data editing, quality control, single point positioning. Then a list of some common commands TEQC software, and made detailed notes)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论


0 个回复

  • MATLAB6signal_process_andtoolbox
    说明:  第一章:MATLAB6 简介 第二章:离散信号及其MATLAB实现 第三章:离散系统及其MATLAB实现 第四章:信号变换及其MATLAB实现 第五章:离散系统的结构及其MATLAB实现 第六.七.八章:基于MATLAB的IIR DF.FIR DF 设计 功率谱估计(Chapter I: MATLAB6 Introduction Chapter II: MATLAB realization of discrete signal and its Chapter III: discrete-time systems and its achievement of Chapter IV of MATLAB: MATLAB realization of the signal transform and its chapter V: the structure of discrete-time systems and its achievement of sixth MATLAB. 7 . VIII: MATLAB-Based Design of IIR DF.FIR DF power spectrum estimation)
    2008-10-30 15:19:49下载
    积分:1
  • RL_half_wave
    MATLAB/SIMULINK Simulation of Halfwave converter circuit with RL Load along with B.M file attached
    2010-09-11 21:21:17下载
    积分:1
  • CNN
    CNN - Convolutional neural network class This project provides matlab class for implementation of convolutional neural networks. Deep Neural Network It provides deep learning tools of deep belief networks (DBNs). myCNN is a Matlab implementation of convolutional neural network (CNN).
    2021-04-18 20:38:51下载
    积分:1
  • OQPSK
    基于OQPSK调制的瑞丽衰落信道的性能分析与仿真(Performance analysis and Simulation of Rayleigh fading channel based on OQPSK modulation)
    2017-12-11 08:49:22下载
    积分:1
  • VESPRITlike
    可以直接计算信号的四阶累计量,挺不错的小程序,注意信号必须是非高斯信号哟。(Signals can be directly calculated fourth-order cumulant, very good small procedures, the attention signal must be a non-Gaussian signal yo.)
    2007-11-27 11:46:28下载
    积分:1
  • ICEE-574
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:54:09下载
    积分:1
  • BLIND-IDENTIFICATION-OF-LINEAR-CHANNELS-USING-THE
    BLIND IDENTIFICATION OF LINEAR CHANNELS USING THE DATA CONSTELLATION
    2014-02-20 10:39:25下载
    积分:1
  • LMS
    说明:  LMS自适应滤波器是使滤波器的输出信号与期望响应之间的误差的均方值为最小,因此称为最小均方(LMS)自适应滤波器。(LMS adaptive filter is to minimize the mean square value of the error between the output signal of the filter and the expected response, so it is called LMS adaptive filter.)
    2020-05-18 17:07:40下载
    积分:1
  • saleh
    MATLAB编写的无记忆功放的Saleh模型函数(Written in MATLAB Saleh memoryless amplifier model function)
    2020-10-22 14:37:23下载
    积分:1
  • photometricStereo
    matlab code for photometric stereo
    2010-12-30 03:14:44下载
    积分:1
  • 696518资源总数
  • 104921会员总数
  • 16今日下载