登录
首页 » matlab » extend2

extend2

于 2010-05-15 发布 文件大小:1KB
0 201
下载积分: 1 下载次数: 86

代码说明:

   Input: x: input image ru, rd: amount of extension, up and down, for rows cl, cr: amount of extension, left and rigth, for column extmod: extension mode. The valid modes are:主要用于图象处理和模式识别( Input: x: input image ru, rd: amount of extension, up and down, for rows cl, cr: amount of extension, left and rigth, for column extmod: extension mode. The valid modes are:)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Untitledday1b
    南海的风速流场,每三度画一个大小为1m/s,方向为45度的流速矢量(Wind flow field the South China Sea, each a third-degree painting of size 1m/s, the direction of the velocity vector of 45 degrees)
    2014-08-09 09:35:12下载
    积分:1
  • Tsinghua-Matlab_Simulink-exercise
    《Matlab/Simulink通信系统建模与仿真实例分析学习辅导与习题详解》一书配套关盘,包含全部m文件、simulink模块(" Matlab/Simulink modeling and simulation of communication systems to learn counseling and case study exercises Comments," closed the book supporting disk, containing all the m file, simulink block)
    2011-09-13 10:04:15下载
    积分:1
  • Previous_LotsObjs_NoArea
    m-file to convert RGB2grayscale
    2012-10-24 23:09:41下载
    积分:1
  • Solving-ODEs-with-Matlab
    讲述ODE初值问题、边值问题和时滞问题的英文资料(This book is for people who need to solve ordinary differential equations (ODEs), both initial value problems (IVPs) and boundary value problems (BVPs) as well as delay differential equations (DDEs).)
    2012-11-28 16:16:36下载
    积分:1
  • particlefilter
    % % set some variables in the workspace to control behaviour: % % graphicsMode 0 no graphics, % 1 graphics, particles, beacons, ground truth % 2 graphics, as above + range circles % % perfect 0 use beacon range data % 1 use ground truth range data % clear a( Set some variables in the workspace to control behaviour: graphicsMode 0 no graphics, 1 graphics, particles, beacons, ground truth 2 graphics, as above+ Range circles perfect 0 use beacon range data 1 use ground truth range data clear a)
    2007-09-30 10:38:28下载
    积分:1
  • glpf
    这段代码主要是实现二阶高斯低通滤波器,本段代码全部用MATLAB语言实现的。(This code is to achieve second-order Gaussian low-pass filter, the above code to achieve the full use of the MATLAB language.)
    2009-06-08 12:41:45下载
    积分:1
  • output
    motion detctor code in a videooo
    2013-12-06 16:47:21下载
    积分:1
  • AR模型功率谱估计
    用现代谱估计法中的AR模型对信号进行功率谱估计(The power spectrum of the signal is estimated by the AR model of the modern spectral estimation method)
    2017-06-27 21:24:37下载
    积分:1
  • QAM
    编写一个含QAM传输的发送和接收模块 1)分别采用复基带仿真和实带通仿真两种形式 a) 实带通仿真时, 载波频率为符号率的4倍 b)发端采用滚降系数0.5的根号升余弦滤波器 2)画出Eb/N0=15dB时的接收波形(收滤波前),取100个采样 3)画出发端输出的眼图和收端过匹配滤波后的眼图(画眼图时不加噪声) 统计误符号率和误比特率与Eb/N0的关系,画出曲线, 与理论计算的曲线相对比 (Prepare to send of one with QAM transmission and receiver module 1), respectively, the complex baseband simulation and the real band-pass simulation in two forms a) the real band-pass simulation, the carrier frequency used for the symbol rate of 4 times b) the originator roll-off factor of 0.5 root raised cosine filter, 2) draw Eb/N0 = 15dB when the received waveform (closing filter), take 100 samples) to draw the originator of the output eye diagram and income side of the eye diagram after the matched filter ( draw the eye diagram without noise) statistics symbol error rate and bit error rate and Eb/N0, draw a curve calculated with the theoretical curve compared)
    2012-05-29 16:51:47下载
    积分:1
  • Fuzzy_Controller_Design
    建立模糊控制的查询表,隶属度函数为高斯型(Fuzzy control query table)
    2013-04-05 20:18:35下载
    积分:1
  • 696516资源总数
  • 106627会员总数
  • 16今日下载