-
5-references
这是5个有关Kinect face recognition的paper，介绍了kinect的相关知识和人脸识别的一些知识，很有帮助。(face recognition with 3D kinect.)
- 2013-07-09 22:16:16下载
- 积分：1
-
Ground_Air_Defense_System_
The geodesy aspects of Matlab source geodesy aspects Matlab source would be helpful
- 2012-04-09 12:07:36下载
- 积分：1
-
FreeScale
实现一个初始结点为3，最终结点为N的无标度网络，输出数据位邻接矩阵(It s out is a adistance matrix of a free-scale network which initial points is 3 and final points is N )
- 2012-04-13 15:41:06下载
- 积分：1
-
newton_raphson_polynom
newton raphson polynomial with matlab in short code
- 2012-05-28 13:12:13下载
- 积分：1
-
Pcasmlar
基于 matlab 用主元分析对半导体数据进行处理，进行相似度的匹配(Matlab using principal component analysis based on semiconductor data processing, the similarity matching)
- 2013-09-21 14:53:48下载
- 积分：1
-
movie1
推导矩形波导TM模表达式，并以动画形式展示(Derivation of the expression of the rectangular waveguide TM mode, and animated to show)
- 2013-04-17 14:05:29下载
- 积分：1
-
matlab
Matlab in image processing ebook
- 2013-04-21 18:28:38下载
- 积分：1
-
INVERTERPWMcompensater
compensation of dead time effect of the inverter dead time effect causes the impact of the control performance of the INVERTER system, and pointed out that the dead time compensation, the key lies in the current phase of the acquisition, in order to overcome the practical zero of the current ambiguity of the system is proposed based on the two-phase stationary coordinate system under the feedforward dead-time compensation method. by the offset voltage of the three-phase output current cycle Fourier transform is found only compensation 1, 5, 7 harmonic components to eliminate the dead time effect. simulation and experimental results verify the correctness and feasibility of this approach.
- 2013-11-11 23:14:37下载
- 积分：1
-
handselectcontrolpoints
本段代码实现了手动选点的matlab配准，在此代码中只选择了3对控制点，同时从结果可以看出手动选点配准的不精确性，为自动选点配准算法的提出提供了实验依据(This code implements manually selected point matlab registration, in this code to select only the three pairs of control points, and the results can be seen from the point of registration manually selected imprecision, with the choice of site for the proposed automatic registration algorithm provide an experimental basis)
- 2014-02-21 20:31:21下载
- 积分：1
-
Speed_Flux_close_control_VC
基于转速和磁链双闭环的异步电机调速系统，采用空间矢量调制，开关周期10KHz，电网电压380V，转矩最大达30N.m(Based on double closed loop speed and flux of the induction motor speed control system, using space vector modulation, switching cycle 10KHz, grid voltage 380V, maximum torque of 30N.m)
- 2015-09-28 17:46:20下载
- 积分：1
