登录
首页 » matlab » Doppler_Centroid_Estimate

Doppler_Centroid_Estimate

于 2007-06-27 发布 文件大小:1KB
0 204
下载积分: 1 下载次数: 149

代码说明:

  利用能量均衡法对实测的合成孔径雷达回波数据估计出其多普勒中心(use of the energy balance method measured the Synthetic Aperture Radar data to estimate its center Doppler)

文件列表:

Doppler_Centroid_Estimate.m

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • spectralsubtraction
    基于matlab的谱减法仿真。一个本科生做的毕业设计。。。(Matlab simulation based on spectral subtraction. Undergraduates to do a graduation project. . .)
    2010-08-31 13:11:52下载
    积分:1
  • ContemporaryCommunicationSystemsUsingMATLABandSimu
    说明:  《现代通信系统使用MATLAB(第二版)》书中的例子打包。(communication systerm)
    2009-07-29 16:49:12下载
    积分:1
  • LMS
    基于LMS算法的均衡技术在matlab上的仿真应用(Equalization technique based on the LMS algorithm in matlab simulation applications)
    2013-08-28 21:57:31下载
    积分:1
  • Matlab-programming-source-code
    现代机械优化设计Matlab编程源代码及方框图(Modern mechanical optimization design Matlab programming source code and block diagram)
    2013-11-12 14:32:04下载
    积分:1
  • Porn
    石油测井解释单孔隙度分析程序POR源程序 可计算地层孔隙度、地层含水饱和度、渗透率、泥质含量等参数;划分砂泥岩剖面;判断油气水层 (Oil log interpretation porosity analysis program POR single source Calculate formation porosity, formation water saturation, permeability, clay content and other parameters divided sand shale section determine gas-water layer)
    2014-05-17 08:46:43下载
    积分:1
  • ctrllab3.0
    很优良的PID控制器设计仿真程序与模型,经过严格检验(Very good simulation of PID controller design procedures and models, to undergo a rigorous inspection)
    2008-05-21 16:23:58下载
    积分:1
  • DoubleInvertedPendulum
    Double Inverted Pendulum Full-order observer design Reduced-order observer design Pole-placement method LQR method LQE method
    2010-12-02 11:20:24下载
    积分:1
  • cdma-codec
    CDMA二代移动通信的Matlab仿真程序段,运行良好。(CDMA second-generation mobile communication segment of the Matlab simulation program, run well.)
    2009-12-28 20:26:27下载
    积分:1
  • feature_detection-using-corner-and-edge
    This program is used for feature detection using corner and edge detection
    2011-09-29 18:26:13下载
    积分:1
  • analysiszhuchengfen
    针对主成分分析的很实用的程序,只需要把所掌握的数据带入,就可以获得一系列的数据,包括相关矩阵、载重、主成分贡献率等。(Principal component analysis and practical program, simply put into the master data, you can get a range of data, including the correlation matrix, load, principal component contribution rate.)
    2012-08-31 16:41:25下载
    积分:1
  • 696516资源总数
  • 106562会员总数
  • 4今日下载