-
decoupled
It do the decoupled load flow in power system
- 2016-11-03 18:24:14下载
- 积分:1
-
nE555
使用15单片机测量ne555的频率,频率范围 1--20000hz(Measuring the frequency of NE555 with 15 single chip microprocessor in the frequency range of 1-20000hz)
- 2020-06-18 10:00:01下载
- 积分:1
-
STM32 硬件SPI_中文显示测试源码
说明: 基于STM32F103的ST7735s芯片的LCD中文显示例程(LCD Chinese Display Routine Based on ST7735s Chip ST32F103)
- 2020-11-16 15:29:39下载
- 积分:1
-
430
msp430f1**系列单片机机的源程序,适合单片机初学者的c程序。(msp430f1** Series MCU machine source code, suitable for beginners SCM c program.)
- 2013-09-10 23:08:03下载
- 积分:1
-
ATT7053
ATT7053AU用户手册,代码,测试报告,答疑等,做单向电表的好选择(ATT7053AU user manual, applications, test reports, Q & A, etc., to make a good choice for one-way meter)
- 2013-06-16 15:47:15下载
- 积分:1
-
My_TDIF2
Mapreduce实现的TF-IDF词频统计分析,可以直接运行于HADOOP环境下(Analysis of TF-IDF statistical Mapreduce to achieve, can be directly run in HADOOP environment
)
- 2020-06-30 02:40:02下载
- 积分:1
-
freemodbus-v1.5.0 官方源码
freemodbus-v1.5.0无改动官方源码,可移植(Freemodbus-v1.5.0 Portable without changing official source code)
- 2020-06-18 00:00:01下载
- 积分:1
-
STM32LED
奋斗STM32开发板例程stm32GPIO口LED闪烁(Struggle STM32 development board routines stm32GPIO of port LED blinks)
- 2012-09-03 11:40:31下载
- 积分:1
-
2.程序
说明: 在此基础上,设计一种温度测量系统,能够检测温度,并通过按键调整温度的上下限值,若超过该限值,进行报警提示。该系统的硬件子电路主要用Protues仿真软件实现,具体的子电路包括:恒流源电路(TLC2543芯片)、信号放大调理电路(两线制铂电阻PT100)、单片机最小系统(AT89C51)、A/D转换电路、按键电路、显示电路、声光报警器等。该系统的软件电路以C语言为基础,在Keil中实现。最后通过软硬结合,实现电路的各种情况仿真,以此验证电路设计的正确性和合理性。(On this basis, a temperature measurement system is designed, which can detect the temperature and adjust the upper and lower limits of the temperature by pressing the key. If it exceeds the limit, an alarm will be given. The hardware sub circuit of the system is mainly realized by Proteus simulation software. The specific sub circuits include: constant current source circuit (TLC2543 chip), signal amplification and conditioning circuit (two-wire platinum resistance PT100), minimum system of single chip microcomputer (AT89C51), a / D conversion circuit, key circuit, display circuit, sound and light alarm, etc. The software circuit of the system is based on C language and implemented in keil. Finally, through the combination of hardware and software, the circuit simulation is realized to verify the correctness and rationality of the circuit design.)
- 2021-01-20 10:36:29下载
- 积分:1
-
receive
单片机的串口接收程序,C语言实现编程,通讯模式是RS232模式。(MCU serial receiving procedures, C language programming, the communication mode is RS232 mode.)
- 2013-07-19 10:14:53下载
- 积分:1