-
UTUKFUPF
说明： UT、UKF、UPF的课件，对学习非线性滤波的人员很有参考价值。(UT, UKF, UPF courseware, learning nonlinear filtering valuable personnel.)
- 2008-08-27 20:43:39下载
- 积分：1
-
Fuzzy-PID
将自适应模糊PID的控制方法应用于电液伺服控制系统中，通过使用MAⅡAB的
FuzzY工具箱对系统建模和仿真计算，并可根据仿真结果在线调整PID参数，对系统进行校
正．(The adaptive fuzzy PID control method is applied to electro-hydraulic servo control system, through the use of MA Ⅱ AB' s FuzzY toolbox on the system modeling and simulation, and can be adjusted according to the simulation results of PID parameters online, the system calibration.)
- 2010-05-29 11:49:07下载
- 积分：1
-
IDCOM-controller-design
IDCOM controller design!
- 2012-05-12 17:32:22下载
- 积分：1
-
lyapunov1
分型计算李雅普诺夫指数的一个程序，可以参考(Typing a program Lyapunov exponent calculation, reference)
- 2014-02-25 21:23:26下载
- 积分：1
-
single_machine
电力系统稳定器，maylab模型，有无pss。功能测试良好。(pss，matlab model,it can work welll. )
- 2020-12-29 23:59:00下载
- 积分：1
-
pttwbveu
本科毕设要求参见标准测试模型，利用贝叶斯原理估计混合logit模型的参数，含噪脉冲信号进行相关检测,针对EMD方法的不足,采用热核构造权重。( Undergraduate complete set requirements refer to the standard test models, Bayesian parameter estimation principle mixed logit model, Noisy pulse correlation detection signal, For lack of EMD, Thermonuclear using weighting factor.)
- 2016-03-21 22:09:58下载
- 积分：1
-
OFDM-basedWirelessBroadBandSystemSimulator
基于OFDM的无线宽带系统仿真It contains mainly two parts, i.e. link-level simulator and system-level simulator.
Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.
System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.(OFDM-based wireless broadband system simulation It contains mainly two parts, ie link-level simulator and system-level simulator.Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx . Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.System- level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.)
- 2008-01-05 00:08:29下载
- 积分：1
-
tank
fuzzy code in matlab
- 2011-10-17 22:27:33下载
- 积分：1
-
inverter_svpwm_threelevel_Add_BusBalance
说明： 三电平逆变器的建模，可以用于二极管钳位型三电平主电路的设计，采用的是SVPWM算法(Modeling of three level inverter)
- 2021-04-06 00:25:18下载
- 积分：1
-
beatratecalculation
helps to detect ECG QRS wave source and calculates beat rate using wavelets and can be used to achieve accurate detection of QRS waveform
- 2010-08-23 10:00:34下载
- 积分：1
