登录
首页 » matlab » temperateur

temperateur

于 2012-04-14 发布 文件大小:10KB
0 141
下载积分: 1 下载次数: 4

代码说明:

  matlab calcule la temperatur

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • ERA-Modal
    ERA模态参数提取方法,根据特征参数提取(MOdal ERA method)
    2021-03-23 21:59:15下载
    积分:1
  • ode_trap
    说明:  matlab中关于数值分析的一个matlab源程序(numerical analysis matlab on a matlab source)
    2011-03-11 09:45:54下载
    积分:1
  • wavelet-denoising-algorithm-
    基于含噪语音统计特征的小波去噪算法分析与实现的matlab程序(Statistical features of noisy speech based on the wavelet denoising algorithm analysis and implementation of the matlab program)
    2011-05-21 21:26:09下载
    积分:1
  • LPCC
    this is lpcc matlab code
    2013-09-19 05:38:12下载
    积分:1
  • single_phase_grid_pv
    this is a matlab fle that contains a simlin simulaion of a smart grid powered by a photovoltaic planels
    2014-12-31 22:07:28下载
    积分:1
  • MIMOLS
    MIMO阵列的最小二乘算法,LS算法。编写并验证可用。(LS for MIMO array。)
    2015-03-18 21:18:15下载
    积分:1
  • ofdm
    基本说明了OFDM在MATLAB的系统仿真过程,详细说明了OFDM信号的产生过程。(Basic description of the OFDM System Simulation in MATLAB process, described in detail the process for selecting the OFDM signal.)
    2008-07-08 15:04:28下载
    积分:1
  • DSP
    任务: 1) 借助MATLAB画出误差性能曲面和误差性能曲面的等值曲线(参考PPT2.1第17页的两幅图); 2) 写出最陡下降法以及LMS算法的计算公式(取 ); 3) 用MATLAB产生方差为0.05, 均值为0白噪音S(n),并画出某次采样得到的波形(即产生任意一个噪声随机序列); 4) 根据 2)中的公式,并利用 3)中产生的S(n),在 1)中的误差性能曲面的等值曲线上叠加画出采用最陡下降法以及LMS法时H(n)的在叠代过程中的轨迹曲线(参考PPT2.1第17页的右下图的曲线1和曲线2)。 5)用MATLAB计算并画出LMS法时 随时间n的变化曲线(对应S(n)的某一次的一次实现)和e(n)波形; 注意:某一次实现的结果并不能从统计的角度反映实验的结果 的正确性,为得到具有统计特性的实验结果,可用足够多次的 实验结果的平均值作为实验的结果。用MATLAB计算并画出 采用LMS法时,J(n)的100次实验结果的平均值随时间n的变 化曲线(即 生成随机噪声信号并计算结果,重复执行100次, 求平均结果)。 6)在 1)中的误差性能曲面的等值曲线上,叠加画出采用LMS法得到的100次实验中的H(n)的平均值的轨迹曲线; (Task: 1 ) Draw with MATLAB error performance surface and surface contour error performance curve ( refer PPT2.1 two chart on page 17 ) 2 ) Write the steepest descent method and the LMS algorithm formula ( take ) 3 ) Using MATLAB to generate variance of 0.05 with a mean of 0 white noise S (n), and draw a particular sampling waveform ( ie, any noise generated random sequence ) 4 ) based on 2 ) of the formula , and use 3 ) generated in S (n), in a ) the error performance curves superimposed on the surface contour plot using the steepest descent method and the LMS method when H (n) the iterative process in the trajectory curve ( refer PPT2.1 page 17 bottom right of the curves 1 and 2 ) . 5 ) using MATLAB LMS method is used calculate and draw the curve with time n (corresponding to S (n) of a first implementation of a ) and e (n) waveform Note : in a first implementation of the results are not reflected from a statistical point of view of accuracy of the experimental results ,)
    2013-11-08 20:09:06下载
    积分:1
  • CA_TrafficFlowModel
    利用元胞自动机算法实现交通流的数学模型构建和模拟,数据输出为.txt文件(Constructing a mathematical model of traffic flow and simulation with the use of cellular automata algorithms, data output as .txt files)
    2015-04-15 10:09:59下载
    积分:1
  • kuihiu_v64
    小波包分析提取振动信号中的特征频率,采用累计贡献率的方法,相关分析过程的matlab方法。( Wavelet packet analysis to extract vibration signal characteristic frequency, The method of cumulative contribution rate Correlation analysis process matlab method.)
    2016-06-03 16:51:25下载
    积分:1
  • 696518资源总数
  • 105547会员总数
  • 4今日下载