-
hkbu2005
介绍了构造均匀设计表的好格子点算法与生成原理，以中心化偏差为均匀性测度，使用MATLAB编写了生成中心化偏差值最小的均匀设计表的计算机通用程序，通过与文献比较，验证了程序的正确性，得到了更多的均匀设计表(The principle and good lattice points designing uniform design table are introduced，the general MATLAB programs for uniform design table are proposed base on searching the minimum of uniform design table s centered L2-discrepancy. The results shows that the programs are right by comparison of the others.)
- 2009-06-13 22:10:26下载
- 积分：1
-
MCA2aaBcr3.8
说明： 形态学成分分析二维图像(矩阵)使用高度复杂词典和稀疏矩阵促进处罚。(MCA of a 2D images using highly redundant dictionaries and sparstity promoting penalties.)
- 2011-02-22 21:19:59下载
- 积分：1
-
Chapter-5
MATLAB例程无功补偿器statcom的仿真图，运行良好(MATLAB routines reactive power compensator statcom simulation map, well)
- 2011-07-27 09:21:26下载
- 积分：1
-
PI
说明： 利用pid控制永磁同步电机，永磁同步电机的PID控制(PID control of permanent magnet synchronous motor using PID control of permanent magnet synchronous motor)
- 2016-05-15 15:57:19下载
- 积分：1
-
1.Echo-MMSE-LMS
Noise cancellation with Minimum Mean Square Error via LMS algorthim in Matlab simulation software
- 2011-07-21 20:43:20下载
- 积分：1
-
matlab-scripts
MATLAB 退火法，元胞机等程序书写与应用及实例。(MATLAB program)
- 2014-09-13 22:39:43下载
- 积分：1
-
ukf
扩展卡尔曼滤波的MATLAB程序，也许有人能用的到。(Extended kalman filter MATLAB, maybe someone can arrive.)
- 2010-10-15 10:16:26下载
- 积分：1
-
EMC-introduces
电缆的EMC设计分析介绍，具体介绍了场在导线中感应的噪声以及电缆之间的串扰(EMC introduces the design of the cable analysis)
- 2013-12-25 22:47:38下载
- 积分：1
-
kfdemo
在matlab上实现卡曼滤波器的基本功能，分五个基本步骤，运行程序无误，已测试。(Kalman filter in matlab to achieve the basic functions, divided into five basic steps, run the program correctly, has been tested.)
- 2011-04-19 01:45:08下载
- 积分：1
-
four
计算成组滑动的滑窗检测器的最佳门限已知: 击中数N = 128, 组宽n = 8，PF =
10¡ 6，PD = 90 假设以下条件:
(a) 信号不起伏
(b) 忽略天线波束调制
1
(c) 计算PD时忽略目标区以外噪声的影响
组门限(第二门限)为K=8 滑窗的门限(第三门限)为L=16 (滑窗中包含的组数为16)
求解: 最佳的KOPT 和LOPT，对这题做了具体仿真实现。需要的朋友，一定知道很有用。(Optimal threshold calculated as group slidable window detector is known: hit number N = 128, the group width n = 8, PF = 106, PD = 90 assuming the following conditions: (a) signal is not undulation ( b) ignore the antenna beam modulation 1 (c) the calculation of PD ignored outside the target area noise of impact group door limit (the second door limit) for K = 8 sliding window of the door limit (third door limit) for L = 16 (sliding window contains group 16) to solve: the best of the KOPT the LOPT, these questions do specific simulation to achieve. A friend in need, we must know to be useful.)
- 2012-10-18 11:02:12下载
- 积分：1
