登录
首页 » matlab » Music-synthetic-procedures

Music-synthetic-procedures

于 2011-05-22 发布 文件大小:265KB
0 232
下载积分: 1 下载次数: 38

代码说明:

  matlab音乐合成实验程序,分析,以及实验报告(matlab music synthetic experimental procedures, analysis, and experimental reports )

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • demo_bearing_demodulation
    对轴承模拟信号进行解调分析,轴承模型见毕果博士论文(3-14),(3-29);(A demo of demodulation of gear simulation signal)
    2010-06-21 22:15:33下载
    积分:1
  • OFDMQAM
    子载波数 128 位数/ 符号 2 符号数/ 载波 1000 训练符号数 0 循环前缀长度 8 (1/16)*T 调制方式 4-QAM 多径信道数 3 IFFT Size 128 信道最大时延 2 (Subcarriers median number of 128 percent/2 percent symbol symbol number/carrier training symbols 1000 a few 0 cyclic prefix length of 8 (1/16)* T modulation 4-QAM the number of multi-path channel 3 IFFT Size 128 the largest delay channel 2)
    2009-04-26 17:36:54下载
    积分:1
  • CRC
    说明:  通信系统中的CRC校验 降低误比特率 提高通信系统的执行效率(Communication Systems CRC, reduce the bit error rate the efficiency of communication systems)
    2011-04-12 21:33:16下载
    积分:1
  • subband_adpcm
    g.722 coding with matlab(g.722)
    2010-05-07 08:54:43下载
    积分:1
  • Program-of-chap1
    The program about sliding mode control: chap1_1ctrl.m chap1_1plant.m chap1_1plot.m chap1_1sim.m ....
    2013-12-14 16:14:43下载
    积分:1
  • LFMquar
    说明:  脉冲信号调制解决了线性调频信号的调制特性(LFM)
    2010-04-13 09:40:25下载
    积分:1
  • WidebandCBF
    宽带CFB算法 选择合适带宽 得到相应结果(CFB algorithm choose the right broadband bandwidth of the corresponding results obtained)
    2011-04-26 22:28:44下载
    积分:1
  • Genetic-Algorithms
    Genetic Algorithm using matlab
    2013-11-13 09:40:04下载
    积分:1
  • UCA_ULA_ujwol
    radiation pattern of dipole
    2010-12-04 02:49:30下载
    积分:1
  • trns
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:45:44下载
    积分:1
  • 696516资源总数
  • 106913会员总数
  • 8今日下载