-
matlab-modeling-algorithm(2)
本资料包含了系统的matlab建模用算法(This pack contains the system matlab modeling algorithm used)
- 2013-08-03 19:45:05下载
- 积分：1
-
HalfBridgeInverter
matalb/simulink model of half bridge inverter using PWM techniqui
- 2013-08-26 05:56:58下载
- 积分：1
-
GetJacobianMatrix
生成雅克比矩阵包括IEEE14 IEEE30 节点的都可以希望对你有用(Generate Jacobian matrix includes IEEE14 IEEE30 node can hope useful to you)
- 2015-04-19 09:01:05下载
- 积分：1
-
MY_MPCController3
基于模型预测控制的，运动学的轨迹跟踪控制器设计(Based on model predictive control, the kinematic trajectory tracking controller design)
- 2020-12-04 10:49:23下载
- 积分：1
-
GeoReviseSection
在工程应用中经常需画剖面图，改程序能帮助你迅速画出剖面图(In engineering applications often need to draw profile, change program can help you quickly draw profiles)
- 2009-11-12 12:18:54下载
- 积分：1
-
tasking_demo_autotrans_sfun
power system comunication and design
- 2011-09-13 18:56:17下载
- 积分：1
-
Permanent-magnet-synchronous-motor
Mysmo.mdl
永磁同步电机的主程序，可以实现有速度传感器启动运行，和无速度传感器运行。
SMOmodel.m
改进的滑模观测器模型，实现永磁同步电机反电动势的估算。
PFCDCM0hm5
用的是0.5hm的电感，实现220V交流电变换成400V的直流电，电流断续。
由于是仿真，如果要硬件实现的话，除了需要电压采样外，还需要一个输入电压过零检测
PFCCM320percent98k50
用的是5hm的电感，实现220V交流电变换成320V的直流电，电流连续。功率因数可以达到0.98，用的开关频率为50K
PFCCM400percent97k50.mdl
用的是5hm的电感，实现220V交流电变换成400V的直流电，电流连续。功率因数可以达到0.97，用的开关频率为50K
(Permanent magnet synchronous motor Mysmo.mdl main program, you can achieve the speed sensor up and running, and speed sensors run. SMOmodel.m improved sliding mode observer model permanent magnet synchronous motor back-EMF estimates. PFCDCM0hm5 with is 0.5hm inductor to achieve 220V AC transform into a 400V DC current is interrupted. As the simulation, hardware implementation, then, in addition to the voltage sampling an input voltage over zero detection PFCCM320percent98k50 the is 5hm inductance to achieve transformation 220V AC 320V DC continuous current. The power factor can reach 0.98, the switching frequency for 50K PFCCM400percent97k50.mdl with is 5hm inductance 220V AC transform 400V DC continuous current. The power factor can reach 0.97, with the switching frequency is 50K)
- 2012-07-26 18:03:33下载
- 积分：1
-
NOISE-REDUCTION-GUI
Low-pass filters allow the low frequency components of an input signal to pass through while attenuating (reducing) high frequency components. Measurement noise fall into the high frequency range of the signal spectrum, while the underlying process signal usually lies towards the low frequency end. Thus filters that are used to remove noise from measurements are of the low-pass types.
This program uses Chebyshev FIR low pass filter based on antenna theory approach to filter noise from human speech signal.
- 2013-04-20 18:01:15下载
- 积分：1
-
fuzzy_pid_nodis
This control system has been successfully applied in some 750mm hot strip mill. The actual record curves indicate that the dynamic feedforward strategy can do well in controlling the tail temperature. And the FuzzyPI-Smith system can get better dynamic characteristic and effectively overcome the problems by pure lag with the traditional
- 2013-05-20 11:24:58下载
- 积分：1
-
MeanShift
Mean Shift 这个概念最早是由Fukunaga等人[1]于1975年在一篇关于概率密度梯度函数的估计中提出来的,其最初含义正如其名,就是偏移的均值向量,在这里Mean Shift是一个名词,它指代的是一个向量,但随着Mean Shift理论的发展,Mean Shift的含义也发生了变化,如果我们说Mean Shift算法,一般是指一个迭代的步骤,即先算出当前点的偏移均值,移动该点到其偏移均值,然后以此为新的起始点,继续移动,直到满足一定的条件结束.
用matlab实现mean shift算法仿真(Mean Shift the concept was first used by Fukunaga et al [1] in 1975 in an article on the probability density function estimation of gradient raised its original meaning, as its name implies, is the offset of the mean vector, where is the Mean Shift a noun, it refers to a vector, but with the Mean Shift the development of the theory, Mean Shift the meaning has changed, if we say that Mean Shift algorithm, generally refers to an iterative steps, namely, first calculate the current point Mean offset, move the shift points to its average, and then as a new starting point and continue to move until the end to meet certain conditions. realize using mean shift algorithm matlab simulation)
- 2009-02-11 20:58:57下载
- 积分：1
