-
MICA
MICA软件包，可在MATLAB 5或MATLAB 6环境下运行(MICA package, MATLAB 5 or in the MATLAB 6 environment running under)
- 2008-04-15 16:54:49下载
- 积分：1
-
IIR-filter-design
基于matlab的IIR滤波器设计，程序简单易懂(Matlab-based IIR filter design procedures are simple)
- 2013-11-04 21:07:16下载
- 积分：1
-
CS4VM
cs4vm算法，是实现半监督学习的较好的方法，能够对多种数据集进行测试，代码中包含例子，下载即可以使用(cs4vm algorithms, semi-supervised learning is to achieve a better way to test a variety of data sets, the code contains examples that can be used to download)
- 2011-10-14 20:40:28下载
- 积分：1
-
code
MATLAB，由浅入深 源代码 打包压缩 ( code example)
- 2011-12-06 00:14:46下载
- 积分：1
-
11
说明： 用MATLAB实现GMSK信号的产生与解调(Using MATLAB to achieve GMSK signal generation and demodulation)
- 2008-11-23 16:48:11下载
- 积分：1
-
pfc_NR
％ 该Matlab程序基于牛顿－拉夫逊算法，用于计算已知导纳矩阵、PQ节点、PV节点、平衡节点(UA)的电力网络潮流
％ U - 各节点母线电压 S - 各节点注入功率 S_net - 电力网络总损耗
％ PQ_P - 实算PQ节点注入有功功率 PQ_Q - 实算PQ节点注入无功功率
％ delt_PQ_P - 实算PQ节点有功功率修正值 delt_PQ_Q －实算PQ节点无功功率修正值
％ delt_UA_P - 实平衡节点有功功率修正值 delt_U_2 - 实平衡节点电压平方修正值
％ delt_PQV - 实算P Q U^2修正值 J - 雅可比矩阵
％ e - 电压实部 f - 电压虚部 delt_ef - 电压实部与虚部修正值( The Matlab program based on the Newton- Raphson algorithm is used to calculate the admittance matrix is known, PQ node, PV node, the node balance (UA) the trend of the electricity networks U- the node bus voltage S- each node injection power S_net-- The total loss of electric power networks PQ_P- operator PQ is injected into active nodes PQ_Q- operator PQ is injected reactive power node delt_PQ_P- is considered the correct value of active power PQ node delt_PQ_Q- really count PQ node reactive power to amend the value of delt_UA_P- real active power balance of the correct value of the node delt_U_2- node voltage balance is the correct value of the square of delt_PQV- really count PQU ^ 2 the correct value of J- Jacobian matrix e- voltage real part f- the imaginary part of voltage delt_ef- voltage real part and imaginary part of the amendment value)
- 2006-11-06 21:20:24下载
- 积分：1
-
2013TSP
通过并行压缩进行二维信号压缩，提出了一种利用并行压缩传感技术对二维信号进行压缩的新方案。根据这个原理，译码器的重新构造可以并行进行。通过对二维信号进行某些排列，可以确保所有列具有大致相同的密度级别，并且可以使用相同的测量矩阵进行采样。这样可以避免二维信号的矢量化，从而大大减小测量矩阵的尺寸。我们证明，如果排列良好，重建均方误差的上限会更紧。为了说明这一方案，我们将其应用于视频压缩并使用不同帧的排列有两种：参考帧的基于Z字形扫描的排列和非参考帧的基于块测试的排列。仿真结果表明，在相同的压缩比下，峰值信噪比比比在无置换情况下可提高3-7db左右。(we propose a new scheme to compress 2D signals using parallel compressed sensing. According to this seheme, the reeonstruction at the decoder can be performed in parallel. By performing certain permutation on a 2D signal, all columns are insured to have approximately the same density level and can be sampled using the same measurement matrix. In this way, vectorization of a 2D signal can be avoided, and thus the size of the measurement matrix can be dramatically reduced. We prove that with a good permutation, we can have a tighter upper bound on reconstruction mean square error. To illustrate this scheme, we apply it to video compression and use
two kinds of permutations for different frames: the zigzag-scanbased permutation for reference frames and the block-test-based permutation for non-reference frames. Simulation results show that under the same compression ratio, the peak signal-to-noise ratio can be improved by approximately 3-7 dB compared to the case without permutation.)
- 2019-01-12 22:48:49下载
- 积分：1
-
code
说明： matlab的程序cnn编写，对图片进行分类并预测，最后完成搜索功能， 输入图片路径给出所有同类的图片结果(matlab program cnn train and predict search function and so on)
- 2020-11-25 16:43:25下载
- 积分：1
-
hht2002
黄变换的代码，经验模式分解，可用于信号分解(Huang transform the code, empirical mode decomposition can be used for signal decomposition)
- 2007-12-21 17:29:30下载
- 积分：1
-
CISVM
代价区间的代价敏感支持向量机，用于代价不能精确获得的情况。(CISVM is a package for learning with cost intervals. It can be used when the precise cost information is not known while cost intervals are available.
)
- 2011-05-12 16:06:30下载
- 积分：1
|
联系客服（QQ：3324461878）
