-
NonlinearPSystems(3rdPEdition)
控制系统，自动化专业经典教材《非线性系统》英文第三版(Control systems, automation classic textbook " nonlinear systems" English Third Edition)
- 2013-08-31 11:41:58下载
- 积分：1
-
TLV5616(For_MSP430)
1、本程序的前提是CS引脚接地，基准电压设定为1.372V
2、“data=temp*4096/2.745”语句是为了实现将所需输出的模拟值直接转化为编码，减少计算量
3、TLV5616最大输出电压是基准电压的两倍，输出电压最大范围是0~Vdd-0.1V,另外基准电压的输入范围为0~Vdd-1.5V(TLV5616文档中有注明，使用时请注意)
(1, the premise of this program the CS pin grounded, the reference voltage is set to 1.372V
2, "data = temp* 4096/2.745" statement is in order to achieve the desired output of the analog values are converted directly to the coding, to reduce the amount of calculation
3, TLV5616 maximum output voltage is twice the reference voltage, the output voltage range is 0 to Vdd-0.1V, another reference voltage input range of 0 to Vdd-1.5V (of the TLV5616 document has stated, use note ))
- 2012-11-11 18:16:14下载
- 积分：1
-
SOURCE
CH375 与电脑通信程序 使用主芯片是瑞萨单片机
- 2012-04-18 09:04:43下载
- 积分：1
-
chengxu
在下的毕业设计， 本题要求设计一个直流电机控制系统。在设计中，采用国产单片机中目前比较新式的STC12C5A60S2作为整个控制系统的控制电路的核心，因为STC12C5A60S2内部有PCA模块，可以产生PWM波形；采用带中断的独立式键盘作为命令的输入，每当按键时蜂鸣器响；配以LCD12864显示实现对带光码盘的直流电动机转速参数的测量、显示和控制。LMD18200驱动模块内部是H型驱动电路，驱动能力较强，完成电机正反转以及速度的控制。为优化直流电机的响应，采用PID反馈，实现闭环控制。(Graduation in the next, and that the requirements to design a DC motor control system. In the design, the use of the relatively new domestic microcontroller as a control circuit of STC12C5A60S2 entire control system core, because STC12C5A60S2 internal PCA module can generate PWM waveforms using a separate keyboard with interrupt input as a command, whenever the button When the buzzer sounds accompanied LCD12864 display realize the measurement of the optical encoder with DC motor speed parameters, display and control. LMD18200 internal drive module is H-drive circuit, driving ability, and the speed of completion of the motor reversing control. In order to optimize the response of DC motor, using PID feedback, closed loop control.)
- 2014-01-23 09:26:35下载
- 积分：1
-
DS2784库仑计测试
DS27xx系列的代码，库仑计测量电量的，（最好能够使用DS2780K来直接设置）(DS27xx series of code, coulometric meter measuring the amount of electricity (preferably by using DS2780K to set it directly))
- 2021-04-13 01:28:56下载
- 积分：1
-
Timer_key_1602
说明： 利用MSP430单片机实现5分钟倒计时。用Timer_A实现1s定时，4位共阳型数码管显示时间，显示格式为：“x-xx”，分别代表“分”、“十秒”和“秒”。每隔1s，倒计时器的时间减1，倒计时从4分59秒开始计时，至0分0秒结束，停止计时。(MSP430 microcontroller is used to realize 5 minute countdown. Timer_A is used to realize 1s timing and 4-bit common-sun digital tube display time. The display format is "x-x x", representing "minutes", "ten seconds" and "seconds" respectively. Every 1s, the countdown time is reduced by 1. The countdown time starts at 4:59 seconds and ends at 0:0 seconds.)
- 2019-04-08 20:51:10下载
- 积分：1
-
DS18B20peratureConversionSubroutine
DS18B20芯片的温度转换子程序精度为0.5(Temperature Conversion Subroutine)
- 2009-04-07 18:11:15下载
- 积分：1
-
Key_Scan
单片机，通过串行扫描，读取矩阵的键盘码。(Microcontroller reads the keyboard codes.)
- 2015-03-02 15:19:26下载
- 积分：1
-
16点音乐fft 32x64双接口
08接口LED控制程序，51单片机，源码文件，测试通过(08 interface LED control program, 51 SCM)
- 2017-07-01 23:30:44下载
- 积分：1
-
Frequency-Meter
基于90s2313的计算机并口频率计，有图纸和源代码(Parallel computers based 90s2313 frequency meter, there are drawings and source code)
- 2013-12-22 08:51:18下载
- 积分：1
