登录
首页 » matlab » trial4

trial4

于 2006-12-14 发布 文件大小:1KB
0 184
下载积分: 1 下载次数: 26

代码说明:

  求出laguerre滤波器的分子分母系数,绘出其幅频响应图并与FIR滤波器作比较。该程序为19阶Laguerre低通滤波器和22阶带通滤波器(obtained laguerre filter coefficient of molecular denominator, chart its amplitude frequency response plans with the FIR filter for comparison. The procedure for the 19-Laguerre low-pass filter and 22 band pass filter)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • mfiles2
    关于MATLAB的仿真的一些资料,非常完整,很不错全面的(MATLAB simulation on some of the information, very complete, very good overall)
    2010-10-05 13:24:06下载
    积分:1
  • 3DBeam_fre
    空间梁验证算例 算例1 计算一空间圆杆形悬臂梁,截面尺寸为,直径 厘米,长度 米,弹性模量 质量密度 。 (Spatial beam validation example calculation of a space for example a rod-shaped cantilever beam, cross-sectional size, diameter cm, length m, elastic modulus, mass density.)
    2010-03-08 12:14:53下载
    积分:1
  • Spread-Spectrum-Multiple-Access-Communications
    Spread Spectrum Multiple Access Communications
    2015-08-04 07:27:33下载
    积分:1
  • New-Folder
    In power engineering, the power flow study (also known as load-flow study) is an important tool involving numerical analysis applied to a power system.
    2011-07-13 23:34:08下载
    积分:1
  • dl
    说明:  有导师学习神经网络的回归拟合-基于近红外光谱的辛烷值预测(Learning regression neural network fit- based on near-infrared spectroscopy octane forecast)
    2014-10-12 21:51:13下载
    积分:1
  • Indirect-adjustment
    本资源是matlab的进行间接平差运算的源代码(This resource is the indirect adjustment calculation matlab source code)
    2013-12-03 20:51:33下载
    积分:1
  • task31
    说明:  工序调整:因为实际因素的影响,在任务11开始之前必须先完成任务15,而在任务9(顶部施工)开始到第7周后必须穿插1周时间的安装工作,因而任务10中的“照明系统”工作周数也相应减少1周;(Adjustment process: since the actual factors, the task must be completed 11 missions before the start of 15, while in task 9 (top construction) began to be interspersed 7 weeks 1 week after the installation time, thus the task of 10 in &quot lighting systems &quot work week is also a corresponding reduction in the number of 1 week )
    2010-03-31 10:50:35下载
    积分:1
  • bilinear_interpolat2
    说明:  双线性插值matlab代码。 子函数: bilinear_interpolat2()采用双线形插值实现图像放大 参数说明: I_in - 输入待放大图像 N - 放大系数 I_out - 返回的放大图像
    2011-04-02 21:02:22下载
    积分:1
  • linzhirenSVMcode(libsvm)
    说明:  matlab和C语言的SVM编写的程序,据说很有名,很多人以此为蓝本改进(matlab and C language procedures for the preparation of SVM, it is said well-known, many people draw on to improve)
    2008-12-05 17:38:45下载
    积分:1
  • LTE_Channel_Model
    3GPP LTE采用的信道仿真模型,目前在3GPP中的提案均采用这一种信道模型,源码是经过国外著名大学和公司联合完成的,极具珍藏价值。(3GPP LTE the channel simulation model, 3 GPP in the proposal were adopted this channel model. OSS was famous overseas universities and companies jointly complete the great commemorative value.)
    2021-04-22 18:38:48下载
    积分:1
  • 696518资源总数
  • 106148会员总数
  • 10今日下载