-
SAEJ2534
Foreword
The use of reprogrammable memory technology in vehicle electronic control units (ECUs) has increased
in recent years, and is expected to continue in the future. Use of this technology has increased the
flexibility of being able to use a single ECU hardware part to be used in many different vehicle
configurations, with the only difference being the software and calibrations programmed into the unit.
Reprogramming of those ECUs in the service environment also allows for ease of field modification of
system operation and calibrations. Variations in reprogramming capability and the multiple tools
necessary to reprogram vehicles are a burden on aftermarket repair facilities that service different makes
of vehicles.
- 2010-06-24 22:18:29下载
- 积分：1
-
Blinky
led blinking example with pic24fj256ga110
- 2010-07-18 00:25:57下载
- 积分：1
-
Design-of-GSM-in-Home-safe
介绍了一种家居安防系统的硬件电路。采用门磁、热释红外、主动红外、振动、可燃性气
体、烟雾等传感器及新型的安防集成电路， 由高性能收发组件完成外围信号的采集和传送。采用高性价比
的PIC单片机作为主控器件，工作稳定可靠。(Design of the Aptitude Safe--System Circuit in Home--Living
Circumstance)
- 2009-05-14 15:54:56下载
- 积分：1
-
msp430f6638_panio
在CCS环境下用C写的TI的msp430f6638的一个电子琴程序，按不同的按键时，改变频率，蜂鸣器发出不同的声音，并且可实现按一个键播放一段乐曲。(In the CCS environment written in C TI s msp430f6638 an organ program, when you press a different key, change the frequency, the buzzer sounds different, and can be achieved by pressing a button to play a tune.)
- 2020-12-28 20:39:02下载
- 积分：1
-
LEDtest
利用单片机作为芯片，利用点阵按钮通过继电器控制LED灯(Using single chip microcomputer as a chip, using bitmap button by relay control LED lights)
- 2013-08-22 10:32:00下载
- 积分：1
-
DS2438源码
说明： ds2438电源检测芯片初始化，数据读取。(DS2438 power supply detection chip initialization, data reading.)
- 2020-06-20 22:40:01下载
- 积分：1
-
STM32_Stepe-motor
基于STM32的4轴步进电机加减速控制全套工程源码，共有两套；
一套是STM32F103的，另外一套是STM32F405的；
可以同时控制4轴步进电机进行加减速；
速率可以达到100K以上；
(4-axis stepper motor control acceleration and deceleration based STM32 full project source code, there are two
Set is STM32F103 and STM32F405 is another set of
Can simultaneously control four-axis stepper motor acceleration and deceleration
Rate can reach more than 100K)
- 2021-03-02 09:19:34下载
- 积分：1
-
time-synch-matlab
无线传感器网络时间同步（影印版）时间同步算法matlab仿真程序(time synchronization algorithm matlab simulation program in book：Wireless sensor network time synchronization (photocopy) )
- 2020-06-30 16:20:01下载
- 积分：1
-
学习 .zip
某贸易中心共10层，设有载客电梯1部。为了处理问题的方便，有以下的限定条件： （1） 电梯的运行规则是：可到达每层。 （2） 每部电梯的最大乘员量均为K人（K值可以根据仿真情况在10~20人之间确定）。 （3） 仿真开始时，电梯随机地处于其符合运行规则的任意一层，为空梯。 （4） 仿真开始后，有N人(>20人)在该国际贸易中心的1层，开始乘梯活动。 （5） 每个人初次所要到达的楼层是随机的，开始在底层等待电梯到来。 （6） 每个人乘坐电梯到达指定楼层后，再随机地去往另一楼层，依此类推，当每人乘坐过L次（L值可以根据仿真情况在3~10次之间确定）电梯后，第L+1次为下至底层并结束乘梯行为。到所有人结束乘梯行为时，本次仿真结束。 （7） 电梯运行速度为S秒/层（S值可以根据仿真情况在1~5之间确定），每人上下时间为T秒（T值可以根据仿真情况在2~10之间确定）。 （8） 电梯运行的方向由先发出请求者决定，不允许后发出请求者改变电梯的当前运行方向，除非是未被请求的空梯。(a total of 10 layers, with a passenger elevator. To address the issue of convenience, have the following qualifications : (a) lift the operating rules is : can be reached on each floor. (2) each lift crew of the largest volume of all K (K value can be based on the simulation of the 10 to 20 between determined). (3) simulation at the beginning, randomly located in the lift line with its rules of operation arbitrary layer of air staircase. (4) simulation began, a N (gt; 20) at the International Trade Center in one layer, started by ladder activities. (5) Each person must first reach the floors are random, in the bottom wait for the elevator arrived. (6) Each person taken the lift arrived at the designated floor and then another random foot to the floor, and so on, when each rode L (L value c)
- 2021-04-22 14:48:48下载
- 积分：1
-
LCD
基与PIC单片机的所编写的LCD子程序 .(PIC-based microcontroller with LCD subroutines prepared.)
- 2010-05-29 16:23:11下载
- 积分：1
