-
matlab.yinqing
用VC++和MATLAB的混合编程可以实现很多强大的功能，本例即是其中用MATLAB引擎实现的方法之一(With VC++ And MATLAB programming can be a mixture of many powerful features, that is, in this case is one of MATLAB engine using one of the ways to realize)
- 2008-05-07 13:25:14下载
- 积分：1
-
frequencycoefficients
将图像分为nxn的分块,之后将各分块三个颜色通道的直方图平均化,最后进行离散余弦变化,分别提取各通道低频系数(The image into nxn sub-block after block of all three color channels of the histogram equalization, and finally the discrete cosine change, were extracted from the low frequency coefficients of each channel)
- 2010-11-21 19:00:16下载
- 积分：1
-
RotorReferenceFrame
rotor reference frame model of induction motor
- 2013-12-16 02:35:08下载
- 积分：1
-
ssprop-3.0.1
非线性信道matlab仿真程序，可以实现色散和非线性效应(nonlinear fiber)
- 2014-01-03 12:26:08下载
- 积分：1
-
DBF_s
自适应波束形成MVDR算法和DREC算法matlab程序(MVDR and DREC algorthms)
- 2020-11-26 20:49:31下载
- 积分：1
-
TLD_source
TLD Tracker Matlab Source!!!!
- 2014-12-02 13:54:52下载
- 积分：1
-
OFDMcode42
This code was used for making the practical measurements in section 2.3 of my thesis. This Matlab code allows an OFDM signal to be generated based on an input data file. The data can be random data, a grey scale image, a wave file, or any type of file. The generated OFDM signal is stored as a windows wave file, allowing it to be viewed, listened to and manipulated in other programs. The modified wave file can then be decoded by the receiver software to extract the original data. This code was developed for the experiments that I performed in my honours thesis, and thus has not been fully debugged.
This is the original code developed for the thesis and so has several problems with it. The BER performance given by the simulations is infact Symbol Error Rate.
(This code was used for making the practical measurements in section 2.3 of my thesis. This M atlab code allows an OFDM signal to be generated based on an input data file. The data can be rando m data, a gray scale image, a wave file, or any type of file. The OFDM signal is generated stored as a windows wave file, allowing it to be viewed. listened to and manipulated in other programs. The modified wave file can then be decoded by the receiver software to extract the original data . This code was developed for the experiments th at I performed in my honors thesis, and thus has not been fully debugged. This is the original code developed for the thesis and so ha 's several problems with it. The BER performance given by the simulations is infact Symbol Error Rate.)
- 2007-04-04 22:20:23下载
- 积分：1
-
ram
the mppt algorithm file
- 2014-01-23 13:19:17下载
- 积分：1
-
lpcc
说明： 提取线性预测倒谱系数的matlab程序，使用的是自相关法(Linear prediction cepstral coefficients extracted the matlab program, using the autocorrelation)
- 2011-03-06 19:55:36下载
- 积分：1
-
multisvm
Matlab code for multiclass svm
- 2015-02-15 16:29:30下载
- 积分：1
