登录
首页 » matlab » ssc_battery_management

ssc_battery_management

于 2012-05-30 发布 文件大小:180KB
0 62
下载积分: 1 下载次数: 174

代码说明:

  battery management for electric vehicle

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • PQ
    说明:  PQ分解法电力系统潮流计算MATLAB程序源(PQ decomposition Power Flow MATLAB program source)
    2010-06-13 17:34:22下载
    积分:1
  • QPSK-BER
    产生QPSK信号,根据仿真的数据估计差错概率(Produce QPSK signal and estimate the data according to the error probability)
    2010-07-29 18:55:28下载
    积分:1
  • gausseid
    Gaussian method to solve the nonlinear equations
    2009-06-01 18:02:39下载
    积分:1
  • EnvelopeFromImage
    提取信号包络的小程序,是用matlab编写的。(Extraction of small signal envelope process, It is a matlab file.)
    2009-06-11 20:42:41下载
    积分:1
  • qeihei
    Matlab实现界面友好,利用matlab针对图像进行马氏距离计算 ,抑制载波型差分相位调制。( Matlab to achieve user-friendly, Using matlab to calculate the Mahalanobis distance for the image, Suppressed carrier type differential phase modulation.)
    2016-12-27 17:29:40下载
    积分:1
  • boost
    BOOT PI CLOSE LOOP CONTOLLER
    2013-10-19 18:20:50下载
    积分:1
  • C-17-flight-control-system-review
    :文章从满足C 17设计基本要求人手,阐述了避免严重失速的机理、操纵失效概率、所有发动机停车操 纵以及安全复飞要求。对综合飞行控制系统设计做了介绍。对满足上述要求的FCS特性做了描述。最后对早期的飞行试验结果作了分析。(: Articles from the design to meet the basic requirements of C 17 staff, described the mechanism to avoid serious stall, control failure probability, all the engines go around parking control and security requirements. The integrated flight control system design is introduced. FCS on the properties meet the above requirements was described. Finally, the early flight test results are analyzed.)
    2011-05-02 12:44:52下载
    积分:1
  • windfarm_synmc-psl
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:52:32下载
    积分:1
  • NN_EKF
    基于非线性扩展卡尔曼滤波的Matlab程序(The extended Kalman filter can not only estimate states of nonlinear dynamic systems from noisy measurements but also can be used to estimate parameters of a nonlinear system. A direct application of parameter estimation is to train artificial neural networks. This function and an embeded example shows a way how this can be done.)
    2021-03-31 20:59:08下载
    积分:1
  • runKut5
    5th-order Runge-Kutta integration.
    2012-08-19 20:22:16下载
    积分:1
  • 696524资源总数
  • 103938会员总数
  • 55今日下载