登录
首页 » C++ » lcd12864_KS0108

lcd12864_KS0108

于 2007-05-14 发布 文件大小:2KB
0 118
下载积分: 1 下载次数: 331

代码说明:

  液晶128*64(KS0108)并行驱动,有详细的注释,对初学者有用(LCD 128* 64 (KS0108) parallel-driven, detailed notes, useful for beginners)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • cheng
    滤波器广泛应用于数字信号处理、通信、自动控制领域,但设计可变宽频带有源滤波器则比较困难。利用单片机控制参数可编程的双二阶通用开关电容有源滤波器,精确设置有源滤波器的中心频率f,品质因数Q及有源滤波器的工作方式。本系统主要分为两个部分:即程控滤波器和程控放大器。程控放大器电压增益为40dB,通过单片机控制DA进行分压,可精确实现要求的10dB步进,误差小于0.5 ,通带为100Hz-500KHz,输入电压峰-峰值范围为10mV,在输入范围内无明显失真。由MAX264为核心的滤波器,可设置为高通、低通滤波器。通过单片机直接给出控制频率,使-3dB截止频率在1KHz-20KHz内可调,步进1KHz,误差小于1 。整个系统以52单片机为控制核心,电路简单,性能稳定,且具有较高精度,滤波参数调节通过单片机控制,较为方便。(Filters are widely used in digital signal processing, communications, automatic control area, but the design variable wideband active filter is more difficult. Control parameters using single-chip programmable universal switched-capacitor biquad active filter, active filter accurately set the center frequency f, quality factor Q and the active filter works. The system is mainly divided into two parts: the program-controlled filters and programmable amplifiers. Programmable amplifier voltage gain of 40dB, the DA through the partial pressure of single-chip control, can accurately achieve the required 10dB step, the error is less than 0.5 , passband to 100Hz-500KHz, input voltage peak- the range of 10mV, the input range no significant distortion. By the MAX264 as the core of filter can be set to high pass, low pass filter. Given directly by the microcontroller controls the frequency, the-3dB cutoff frequency at 1KHz-20KHz adjustable, step 1KHz, error is less than 1 . The entire system for)
    2011-07-17 16:23:27下载
    积分:1
  • 3 LED流水灯
    简单的流水灯开发程序,包括流水的类型和电路连接等资料(Simple water lamp development program, including the type of water and circuit connection and other information.)
    2018-05-06 12:53:45下载
    积分:1
  • 05_数码管显示0-9
    基于51单片机的LED 0-9显示,浅显易懂(LED 0-9 Display Based on 51 Single Chip Microcomputer)
    2020-06-17 19:20:02下载
    积分:1
  • RS232
    有单片机控制的RS232实现数据的接受和发送的汇编程序(A microcomputer-controlled RS232 for data acceptance and sent assembler)
    2008-07-25 17:18:55下载
    积分:1
  • uptime
    Injection is controlled by high priority kernel threads, spawned for each online CPU.
    2015-06-18 13:32:42下载
    积分:1
  • spi
    ARM程序,实现了SPI通信协议,可用于任何使用SPI通信协议的器件上,在LPC2103上测试成功。(ARM procedures realize the SPI communication protocol, can be used for any use of SPI communication protocol on the device, tested successfully in the LPC2103.)
    2008-08-23 10:09:43下载
    积分:1
  • tekradius
    一个测试Radius的工具,可以测试Radius服务器是否正确(tekradius this is a good test tool)
    2014-11-03 10:37:26下载
    积分:1
  • ADPCM-Example
    C++源码实现WAV文件的ADPCM编码和解码(C++ source to achieve a WAV file ADPCM encoding and decoding)
    2016-06-03 15:22:48下载
    积分:1
  • 12864(asm)
    用C8051F020驱动LCD:OCM12864显示汉字的汇编源程序。(C8051F020 drive with LCD: OCM12864 show source compilation of Chinese characters.)
    2008-05-29 23:16:14下载
    积分:1
  • OV7670-Hardware-Guide
    OV7670照相模组 硬件应用指南文件只能给那些获得OmniVision Technologies, Inc. 批准的员工、 组织、团体使用。OmniVision公司机密 Table of Contents 1. OV7670 模组参考设计 注 1.PWDN和RESET不用时,应接地 2. OV7670 模组接口参考设计 2.1 引脚定义 2.2 电源供给 3. OV7670 照相模组操作 3.1 节电模式 3.2 照相模组工作在不断电的节电模式 3.2.1 上电,硬件复位 3.2.2 上电,软件复位 3.2.3 由不断电的节电模式恢复工作 3.2.4 不断电的节电模式 3.3 照相模组工作在断电的节电模式 3.3.1 上电 3.3.2 打开摄像头 , 硬件复位 3.3.3 打开摄像头, 软件复位 3.4关闭摄像头 4.SCCB总线共享 5.手机上PCB 设计时序的考虑 5.1 PCLK采样 5.2 用 EMI/ESD 器件 6. 硬件检测 6.1 检查硬件设计 6.1.1 模组功能 6.1.2 检查手机 Camera 接口 6.2 检查Camera 模组是否工作 6.3 检查SCCB 6.4 检查照相模组接口 6.5常见问题 6.6 图片方向 6.6.1 摄像头4:3, LCD 3:4 6.6.2 摄像头3:4, LCD 6.7 检查颜色 6.8 检测图像中心(OV7670 camera module Hardware Application Guide)
    2012-12-18 02:32:06下载
    积分:1
  • 696516资源总数
  • 106409会员总数
  • 8今日下载