登录
首页 » matlab » TCM-16QAM

TCM-16QAM

于 2021-03-05 发布 文件大小:9KB
0 163
下载积分: 1 下载次数: 307

代码说明:

  网格编码的16QAM仿真,验证网格编码的增益和误码(grid coding 16QAM simulation, verification grid coding gain and the error)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论


0 个回复

  • AM
    AM调制系统的设计及仿真,包括载波信号,载波信号频谱,调制信号,调制信号频谱等图像(Design and Simulation of AM modulation and demodulation)
    2018-11-27 14:40:12下载
    积分:1
  • Ofdmchannelqam16
    OFDM modelisation on matlab
    2013-04-12 17:40:22下载
    积分:1
  • OFDM信号频谱感10
    说明:  前已提出的频谱感知方法主要包括匹配滤波器检测、 能量检测、 循环平稳特征检测以及多分辨率频谱感知. 这些方法均为单节点感知方法.然而,在阴影和深度衰落情况下, 单个节点的感知结果并不可靠, 因此, 需要对多个节点的感知结果进行融合,以提高检测可靠性, 即协作感知技术. 文献采用“或” 准则对各个 CR 感知结果进行融合. 文献则提出了基于 D-S 证据理论的协作频谱感知算法,虽然该算法的性能比“或” 准则或“与”准则要好, 但需要存储大量历史信息, 算法的计算复杂度也很高. 文献中分析了采用似然比检测(likelihood ratio test, LRT) 的软判决与采用“与” 准则的硬判决的性能, 结果表明采用软判决的协作感知性能更优(Previously proposed spectrum sensing methods mainly include matched filter detection, energy detection, cyclostationary feature detection and multi-resolution spectrum sensing. These methods are all single node sensing methods. However, in the case of shadow and deep fading, the sensing results of single node are not reliable, so, It is necessary to fuse the sensing results of multiple nodes to improve the detection reliability, i.e. cooperative sensing technology. In the literature, "or" criterion is used to fuse the CR sensing results. In the literature, a cooperative spectrum sensing algorithm based on D-S evidence theory is proposed. Although the performance of the algorithm is better than "or" criterion or "and" criterion, a large amount of historical information needs to be stored, The computational complexity of the algorithm is also very high. In the literature, the performance of the soft decision based on the likelihood ratio test)
    2020-11-19 21:19:37下载
    积分:1
  • modbus-master
    通过串口解析MODBUS协议 读开关量型的输入信号 读保持寄存器上的内容 批量写数据到保持寄存器(Resolving MODBUS Protocol through Serial Port Input signal of reading switch type Read and hold registers Write data in batches to hold registers)
    2020-06-23 20:40:01下载
    积分:1
  • 差分调制与解调
    此代码通过随机生成二进制码,对其进行二进制差分调制,以及加入高斯白噪声后对其解调计算误码率,绘制出其输入信噪比与输出信噪比的实验曲线及理论曲线的比较。(This code generates binary codes randomly, modulates them by binary differential modulation, demodulates them with Gauss white noise and calculates the bit error rate, draws the experimental curve and theoretical curve of their input signal-to-noise ratio and output signal-to-noise ratio.)
    2018-12-17 15:14:55下载
    积分:1
  • 算法仿真代码
    包括极化码基于CRC的SCL译码算法,Lazy Copy机制,定点量化,代码和程序说明文档(Polar code with fast-list-decoder)
    2021-04-12 20:58:57下载
    积分:1
  • RS码的FPGA实现 RS_Verilog
    RS码的FPGA实现,verilog语言形式,好参考资料(FPGA realization of RS code, verilog language form, a good reference)
    2021-04-17 19:28:52下载
    积分:1
  • polarcoding_matlab
    说明:  实现Polar码编码译码,SC译码,简单实用,运行速度快(Polar MATLAB include encode and decode useful and simple)
    2019-04-10 10:33:51下载
    积分:1
  • ethernet_mac-master
    说明:  ethernet mac vhdl verilog basic
    2019-03-30 15:47:25下载
    积分:1
  • dmlandsml
    利用DML算法和SML算法实现到达方位角的估计(Estimation of arrival azimuth using DML algorithm and SML algorithm)
    2018-01-06 09:40:15下载
    积分:1
  • 696518资源总数
  • 105395会员总数
  • 22今日下载