登录
首页 » matlab » FDTD-Capter3

FDTD-Capter3

于 2012-06-03 发布 文件大小:3KB
0 137
下载积分: 1 下载次数: 11

代码说明:

  Dennis M.Sullivan FDTD书后matlab程序 已经调试验证 第三章(Dennis M.Sullivan matlab program using FDTD book have been debug and verify)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • cx6_1
    振动信号频域处理方法___ 随机信号谱分析(Vibration Frequency Domain Analysis of ___ random signal spectrum)
    2011-05-06 16:16:01下载
    积分:1
  • DPSK_matlab
    用matlab实现通信系统中的DPSK差分编码器的源代码(the matlab source code of DPSK)
    2013-03-22 12:58:40下载
    积分:1
  • matlab 傅里叶变换
    matlab 傅里叶变换 图像的傅里叶变换,利用快速傅里叶进行图像的频率分析然后画出图形(Matlab Fourier transform The Fourier transform of the image and of the image by using the fast Fourier frequency analysis and then draw the graphics)
    2020-06-27 10:00:02下载
    积分:1
  • psopid
    基于pso算法优化的PID神经网络的系统控制算法(Pso optimization algorithm based on neural network PID control system algorithm)
    2014-12-03 00:18:59下载
    积分:1
  • ECEFtoWGS84
    ECEF to WGS84 conversion
    2012-10-06 05:37:17下载
    积分:1
  • matlabtomode
    In this context, power management discipline has acquired an increasing interest in the design and manufacture of embedded systems for automotive, consumer and other industrial markets. Therefore, one of the current challenges in the domain of power electronics is the design and implementation of power supplies for the new generation of high-performance CPUs.
    2015-01-10 21:06:38下载
    积分:1
  • 贪婪算法仿真
    说明:  基于matlab平台使用贪婪算法最终实现多智能体覆盖问题(Multi agent coverage problem using greedy algorithm)
    2020-12-19 10:09:12下载
    积分:1
  • NewtonRaphson
    newton raphson MATLAB PROGRAMME
    2014-12-22 01:19:12下载
    积分:1
  • matlab
    设计一个一位二进制数大小比较器。比较两个一位二进制数A和B的大小,电路有三个输出端Y1,Y2和Y3,分别对应A大于B,A等于B,A小于B。当条件满足时,相应输出端为1,否则为0。(A,B用两个脉冲源代替),建立仿真模型并保存。(Design a one binary magnitude comparator. A size comparison of two binary numbers A and B, the circuit has three outputs Y1, Y2 and Y3, respectively, corresponding to the A greater than B, A is equal to B, A less than B. When the conditions are met, the corresponding output is 1, and 0 otherwise. (A, B instead of the source with two pulses), and save the simulation model.)
    2013-12-24 13:16:27下载
    积分:1
  • EASI-seperation
    this is simple matlab code for EASI algorithm in BSS
    2012-08-17 18:57:48下载
    积分:1
  • 696518资源总数
  • 105540会员总数
  • 37今日下载