-
fdbbook
Introduction to the Companion MATLAB Codes (Introduction to the Companion MATLAB Codes)
- 2008-01-04 17:17:13下载
- 积分：1
-
yddl
说明： 压电电缆 技术资料，现在 路考主要 材料(Piezoelectric cable technical data, the main material is a road test)
- 2010-04-25 15:07:57下载
- 积分：1
-
Desktop
lanja lanja.m lanja.m lanja.m v lanja.m
- 2012-04-16 23:34:22下载
- 积分：1
-
x_three_ground
配网故障测距，用于三相短路情况下的配网故障测距，使用双端信息量，可以较好的测距(Distribution network fault location, for the case of three-phase short-circuit)
- 2013-03-14 23:06:50下载
- 积分：1
-
tutorial3
Tutorial Matlab pemula 3
- 2012-04-16 22:13:58下载
- 积分：1
-
dijkstra
dijkstra算法通用，是学习数学建模必不可少的程序呢(dijkstra algorithm for general)
- 2010-09-10 19:48:57下载
- 积分：1
-
MATLABorder
此书中概括了很多MATLAB中的命令，便于查询和学习使用(This book summarizes many of the commands in MATLAB, easy to use search and study)
- 2010-10-28 10:10:24下载
- 积分：1
-
eee
杨氏双缝干涉
两相干光源到接收屏上P点距离r1=(D2+(y-a/2)2)1/2, r2=(D2+(y+a/2)2)1/2,
满足相干条件的光波叠加后，对于观察屏上某一确定点，即r1、r2确定后，叠加后的光强为 式中λ为光波的波长， 、 ，令相位差φ=2π（r2-r1）/λ,
最后可得公式如下：
，
最后光强I=4I0cos2（Φ/2）。
观察相干光叠加后光强的分布.
(Young' s double slit interference two coherent light source to the point P on the receiving screen distance r1 = (D2+ (YA/2) 2) 1/2, r2 = (D2+ (y+a/2) 2) 1/2, meet coherent conditions lightwave after superposition, for a determined point on the viewing screen, i.e. R1, R2 is determined, the superimposed light intensity where λ is the wavelength of light, make the phase difference φ = 2π (R2-R1)/λ, final can be obtained using the following formula: Finally, the light intensity I = 4I0cos2 (φ/2). Observed coherent superposition of light intensity distribution.)
- 2013-01-03 21:04:13下载
- 积分：1
-
3pinghua
基于三次指数平滑法的青岛港集装箱吞吐量预测 资料讲述了采用三次平滑法对吞吐量的预测细节 和思路(Based on the three exponential smoothing forecast container throughput of Qingdao port information about the use of three smoothing forecasts on the throughput of the details and ideas)
- 2010-05-09 14:57:00下载
- 积分：1
-
cclog
A log analysis project, log into the given format identifiable results
- 2014-08-26 16:03:05下载
- 积分：1
