-
NewTextDocument
matlab program for function rotor_oscillation_HVDC_Light
- 2010-12-19 18:50:54下载
- 积分：1
-
ECEFtoENV
地心坐标系下的经纬高坐标数据，转换为东北天坐标系下的坐标。输入为经纬高，单位为°。
matlab文件实现，调用函数名为：ECEFtoENV(Geocentric latitude and longitude coordinates of the high-coordinate data is converted to Northeast day coordinate system coordinates. Latitude and longitude input is high, the unit is.)
- 2013-11-14 17:53:06下载
- 积分：1
-
plane-problem
平面问题有限元代码，自学有限元的时候写的，不喜勿喷(plane problem by finite element method)
- 2013-12-14 19:48:43下载
- 积分：1
-
malabtwork
说明： 移动通信系统 信道，接收机等的MATLAB源代码，较详细(mobile communications MATLAB demo)
- 2009-07-24 20:29:40下载
- 积分：1
-
Learning-to-Program-with-MATLAB_-Building-GUI-Too
Learning to Program with MATLAB_ Building GUI Tools - Craig S. Lent
- 2013-07-24 22:01:26下载
- 积分：1
-
dtw
可实现规整后序列的输出，规整前数据的归一化和反归一化(The output of the normalized sequence can be realized, and the normalization and de-normalization of the pre-normalized data can be realized.)
- 2018-12-03 10:36:59下载
- 积分：1
-
mtetris
特别经典的俄罗斯方块matlab程序！图形不错，界面也做得很好，共享给大家一起学习！(In particular the classic Tetris matlab program! Good graphics, the interface they have done well to share for everyone to learn!)
- 2009-05-06 12:11:16下载
- 积分：1
-
chengxu
小波变换进行变速箱故障诊断
首先将s1和s2信号时域谱（s1代表维修前的振动信号，s2代表维修后的振动信号），画出来进行对比，会发现s1信号的振动幅值会比较高；然后对s1和s2分别进行小波分解并画出各层的时域谱，只对比s1和s2分后的最高时域谱，s2更加的具有周期性，且幅值较小，s2周期性不够明显，且振动过于密集。分析完时域谱后开始分析频谱，首先对原信号s1和s2fft转换，得到频谱图，如图，然后再对小波分析后高频部分进行fft转换，做出频谱图。对比后我们发现，在f 2375HZ出（也就是齿轮的啮合频率），s1信号频谱幅值会有急剧的升高，然后，其谐波的幅值也会增大。所以可以推断出该维修前的增速箱的齿轮可能出现问题。(Gearbox fault diagnosis based on wavelet transform s1 and s2 first time domain signal spectrum (s1 behalf of the vibration signal before maintenance, vibration signal s2 representative of repaired), drawn comparison, you will find a signal s1 vibration amplitude will be higher then s1 and s2 respectively wavelet decomposition and draw the layers of time-domain spectrum to only a maximum time domain spectroscopy s1 and s2 points after, s2 is more cyclical and smaller magnitude, s2 cyclical enough obviously, and the vibration is too dense. End domain spectral analysis after the beginning of the spectrum analysis, the first of the original signal s1 and s2fft conversion to give the spectrum, as shown, and then after the high frequency part of wavelet analysis fft transformation to make spectrum. We found that after the comparison, at f 2375HZ out (i.e. the gear mesh frequency), there will be a sharp increase in the amplitude spectrum of the signal s1, and then, the amplitude of the ha)
- 2017-01-17 19:18:02下载
- 积分：1
-
FCM,GK,GG模糊聚类算法
fcm实现简单的数值分类，只要你重新定义数据矩阵，就可以直接进行分类。(FCM implements simple numerical classification, which can be directly classified as long as you redefine the data matrix.)
- 2021-04-21 15:08:49下载
- 积分：1
-
Wind engineering
说明： 采用离散再合成的随机流动生成(DSRFG)方法合成了满足目标湍流度、积分尺度、脉动风速谱及空间相关性等参数的各向异性湍流;讨论了DSRFG方法在生成湍流风场上关键参数的合理取值;(Anisotropic turbulences satisfying the parameters of target turbulence, integral scale, pulsating wind speed spectrum and spatial correlation are synthesized by discrete resynthesis random flow generation (DSRFG) method. The key parameters of DSRFG method in generating turbulent wind field are discussed. Reasonable value;)
- 2019-04-26 13:19:36下载
- 积分：1
