-
开源平衡小车电路图+代码
说明： 开发平衡小车的参考资料,内含源码和电路图，可以加速你的开发过程(the reference to develop the balance car)
- 2020-06-20 18:00:02下载
- 积分：1
-
RC522Code
使用stm8l152c6硬件SPI控制RC522 可实现读M1卡 文件为IAR工程(Use stm8l152c6 hardware SPI control RC522 enables M1 card reading IAR project files for)
- 2020-08-15 12:48:34下载
- 积分：1
-
gps-asm
c51单片机实现GPS数据接受并通过数码管显示时间(c51 achieve single-chip GPS data receive and display digital time)
- 2009-04-08 18:16:27下载
- 积分：1
-
Principle-of-electronic-load
电子负载原理, 负载效应讲的很好，很多恒压源，恒流源，恒阻源模型(The principle of electronic load, load effect speak well, a lot of the constant voltage source, constant current source, constant resistance source model)
- 2016-11-09 17:10:14下载
- 积分：1
-
cPP-programing
这本C++程序设计书籍由清华大学郑莉所编写是目前C++程序入门的不错书籍。(This C++ programming books written by Tsinghua University Zheng Li is a good introductory book C++ program.)
- 2013-11-25 08:53:02下载
- 积分：1
-
dianzishejidasai2015
本代码是以stm32f407为硬件基础，用mdk5编写的2015年，电子设计大赛，f题数字频率计的源代码。(The code is a hardware-based stm32f407, 2015 with mdk5 written, electronic design contest, f digital frequency meter title of the source code.)
- 2015-08-25 13:58:19下载
- 积分：1
-
digital
基于单片机STC89C51和74LS164的多功能数字万用表(Based on microcontroller STC89C51 and 74 ls164 multi-function digital multimeter)
- 2013-08-29 22:40:03下载
- 积分：1
-
TEST_LCD
Check connect pic16 with LSD 2x16 byte
- 2015-03-25 18:35:59下载
- 积分：1
-
SPWM_Demo_Lcd1602_ATmega8515
一个用AVR单片机ATmega8515输出SPWM波形并驱动一个LED渐亮渐灭的示范程序，输出波形的占空比和频率显示在1602液晶屏上，编译环境Code Vision AVR(AVR with a ATmega8515 SPWM output waveform and an LED driver gradually Liang gradually eliminate the program, the duty cycle output waveform and frequency displayed on the LCD screen 1602, Build Environment Code Vision AVR)
- 2006-10-26 11:22:32下载
- 积分：1
-
FreeRTOS实验17-1 FreeRTOS内存管理实验
硬件资源:
1,DS0(连接在PA8)，DS1(连接在PD2上)
2,串口1(波特率:115200,PA9/PA10连接在板载USB转串口芯片CH340上面)
3,ALIENTEK 2.8/3.5/4.3寸LCD模块(仅支持MCU屏)
4,按键KEY0(PC5)/KEY1(PA15)/KEY_UP(PA0,也称之为WK_UP)
实验现象:
按下KEY_UP键申请内存，内存申请成功以后就可以使用了，按下KEY0键
就是使用申请到的内存。当内存使用完成以后就可以按KEY1键将内存
释放掉。(Hardware resources:
1, DS0 (connected to PA8), DS1 (connected to PD2)
2. Serial port 1 (baud rate: 115200, PA9/PA10 connected on board USB to serial chip CH340)
3, ALIENTEK 2.8/3.5/4.3 inch LCD module (only supporting MCU screen)
4. Keyboard KEY0 (PC5)/KEY1 (PA15)/KEY_UP (PA0, also known as WK_UP)
Experimental phenomena:
Press KEY_UP key to apply for memory, memory application can be used after success, press KEY0 key
That is to use the applied memory. When the use of memory is complete, you can press KEY1 to store the memory.
Release.)
- 2020-06-24 06:00:02下载
- 积分：1
