-
Mark-a-watershed-segmentation
基于标记的分水岭图像分割算法，是通过MATLAB编写的，算法运行比较快，更改读入图像的路径就可以运行。(Watershed image segmentation algorithm based on mark)
- 2021-02-18 17:29:45下载
- 积分：1
-
21642351
Email must the same with registered Email info
EMail:
Email must the same with registered Email info
EMail:
File: Largest 100M, the name should less 40 bytes long and should be English. Only support .rar,.zip,.gz filesM, the name should less 40 bytes long and should be English. Only support .rar,.zip,.gz files
- 2009-11-17 03:44:39下载
- 积分：1
-
load_parameters
this file implements the set-up of the simulation parameters for wimax matlab simulator. can be used for communications simulations. implemented as a matlab function file. very easy to use
- 2012-01-23 23:25:46下载
- 积分：1
-
CHIZHI
用龙格库塔法对迟滞进行建模（JA模型），可运行(Longge kuta method of super hysteresis expansion material modeling, can run, have the result)
- 2020-10-27 21:49:58下载
- 积分：1
-
MATLAB
MATLAB简单的计算白色轮廓中的像素点的个数(MATLAB a simple white outline of the calculation of the number of pixels)
- 2009-11-20 22:23:34下载
- 积分：1
-
1-2DoublebandSpecrum
这是一个双边带频谱分析仿真的Systemview源代码。(This is a bilateral spectrum analysis and simulation with the Systemview source code.)
- 2007-04-07 10:16:47下载
- 积分：1
-
TFA-Matlab
目标因子分析,用于找主因子数，由例子能清晰明了的理解(Target factor analysis, the number of factors used to find the Lord, by the example of clarity of understanding can)
- 2014-01-14 13:08:57下载
- 积分：1
-
function-extreme-genetic-algorithm
运用matlab工具箱的神经网络遗传算法函数进行极值寻优-非线性函数极值(Matlab neural network using genetic algorithm toolbox function optimization Extreme- Extreme nonlinear function)
- 2011-04-27 10:59:20下载
- 积分：1
-
trns
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:45:44下载
- 积分：1
-
inverter1edited
Finally it is observed that by using this filter, the common mode noise level of 2MHz resonant converter is suppressed according to CISPR 22 standard limits
- 2013-09-13 00:51:09下载
- 积分：1
