-
ofdm-siso
正交频分复用是一种多载波宽带数字调制技术。相比一般的数字通信系统，
它具有频带利用率高和抗多径干扰能力强等优点，因而适合于高速率的无线通信系统。(
OFDM Simulator
--------------------------------------------------------------------------------
MIMO OFDM Simulator:
OFDM.m: OFDM Simulator (outer function)
create_channel.m: Generates a Rayleigh fading frequency-selective channel, parametrized by the antenna configuration, the OFDM configuration, and the power-delay profile.
svd_decompose_channel.m: Since full channel knowledge is assumed, transmission is across parallel singular value modes. This function decomposes the channel into these modes.
BitLoad.m: Apply the bit-loading algorithm to achieve the desired bit and energy allocation for the current channel instance.
ComputeSNR.m: Given the subcarrier gains, this simple function generates the SNR values of each channel (each singular value on each tone is a separate channel).
chow_algo.m: Apply Chow s algorithm to generate a particular bit and energy allocation.
EnergyTableInit.m: Given the SNR values, form a table of energy increments for )
- 2009-03-05 20:05:49下载
- 积分：1
-
CRdectection
说明： ：该文首先研究了单认知用户能量检测算法的检测性能和检测灵敏度与检测时长和噪声短时间内平均功率波
动性之间的关系，得出检测性能和检测灵敏度随噪声短时间内平均功率波动性的增大而急剧下降的结论，在低信噪
比时尤为明显；针对检测性能和检测灵敏度随噪声短时间内平均功率波动性的增大而急剧下降，提出了基于多用户
协同能量检测算法。仿真表明，在低信噪比环境下，即使噪声短时间内的平均功率存在较大的波动性，只要适当地
增加协同检测的用户数，仍可获得较为准确的检测性能。(In this paper, detection performance and detection sensitivity with detection duration and noise average
power fluctuation in short time is investigated firstly. Performance accuracy and detection sensitivity drop quickly
with noise average power fluctuation increasing and it is worse when signal-to-noise ratio lower. Considering the
characteristic, a novel new energy detection algorithm based on cooperative is presented. Simulations show that
the proposed scheme improves antagonism of noise average power fluctuation in short time and gets a good
detection performance as long as increasing the number of cooperative detection users.)
- 2010-04-14 14:46:12下载
- 积分：1
-
Target-tracking
说明： 机动目标跟踪的一本书，pdf版的，经典。要看。(Target tracking in a book, pdf version of the classic. Look.)
- 2010-04-27 14:47:19下载
- 积分：1
-
New-Revised-K-means
New revised K-means聚类算法，为matlab函数，需要调用才能使用(New revised K-means clustering algorithm for matlab function, you need to call in order to use)
- 2013-08-19 08:42:12下载
- 积分：1
-
Kinetics
拉格朗日法求解卧式下肢伸屈运动的动力学方程(Lagrange method for solving the dynamic equation of the lower limbs)
- 2016-07-07 22:05:44下载
- 积分：1
-
pid_foc_funs
分数阶PID比一般PID多了2个可调参数，实现了常规PID所无法实现的控制功能，并且更精确有效(Fractional PID PID more than two adjustable parameters, and can not be achieved by the conventional PID control functions, and more accurate and efficient)
- 2021-04-22 19:58:48下载
- 积分：1
-
01389005
very good paper about mimo ofdm
- 2010-11-29 08:43:05下载
- 积分：1
-
shuxue
层次分析法求权重权向量等很多东西09年b提(very good)
- 2010-08-24 12:53:58下载
- 积分：1
-
modifiedconvolution
Powerful and fast image inpainting algorithm used convolution based method
- 2010-09-23 04:34:21下载
- 积分：1
-
windfarm_synmc-psl
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:52:32下载
- 积分：1
