-
dcomp2
this is a how to read a byte in a the image
- 2010-06-25 22:01:56下载
- 积分：1
-
LR
说明： logistic regression algorithm in matlab.
- 2010-11-23 16:25:22下载
- 积分：1
-
l11
rate equation with simulink of matlab
- 2012-04-28 06:14:43下载
- 积分：1
-
randfun
MATLAB 随机种子工具箱，全，十分好用，大家交流(MATLAB random seed kit, full, very easy to use, to share)
- 2011-06-17 13:44:25下载
- 积分：1
-
Experimental-transfer-function
传递函数MATLAB实验传递函数MATLAB实验传递函数MATLAB实验(Experimental transfer function transfer function MATLAB MATLAB MATLAB experiment experimental transfer function)
- 2011-07-19 21:41:54下载
- 积分：1
-
wsn仿真
说明： 降低无线传感器网络能耗，分簇算法，在初学wsn中可以提供较大参考与帮助，希望能帮助初学者。(Reduce energy consumption of wireless sensor network, clustering algorithm)
- 2020-02-23 01:07:33下载
- 积分：1
-
AAM
主动外表模型与主动形状模型，MATLAB平台下使用，内含DEMO(active appearance model)
- 2010-12-25 20:53:26下载
- 积分：1
-
3
说明： 对程序利用matlab对空时编码中的分集技术进行了仿真，通过对比采用分集技术和不采用此技术来进行性能分析(Matlab program for use on space-time coding techniques in the sub-set of the simulation, by comparing the use of diversity technology and do not use this technology for performance analysis)
- 2011-11-22 09:23:55下载
- 积分：1
-
pulse-generate
本程序是矩形波的产生。第零步定义了要产生的波形的所有特征参数，矩形波的持续时间WIDTH，矩形波的采样点数POINTS,载波频率为F0，这个频率的最终引入是便于使用RF频率发射波形。第一步包括产生矩形波，并将其调制到RF上，注意，产生的信号的持续时间是矩形波宽度的5倍，这样，总的采样点数就是5*POINTS。同时还应注意，如果要产生一个基带信号，必须设置T0=0.第二步是画出所产生矩形波的源代码。( This procedure is rectangle wave production. Step to produce stage defined the waveform of all characteristic parameters, the duration of the rectangle wave WIDTH, rectangle wave sampling POINTS POINTS, carrier frequency F0, this frequency for the ultimate introduction is easy to use RF frequency emission waveforms. The first step including generating rectangle wave, and modulated to RF, attention, produce the duration of the signal is five times the width of rectangle wave, so, overall sampling POINTS is 5* POINTS. Also, note that if you want to produce a baseband signals must set T0 = 0. The second step is to draw a rectangular wave generated by the source code. )
- 2011-05-21 10:52:01下载
- 积分：1
-
HHTtransformanalysisofpressurepulsewavesignal
本文采用的是先对脉搏波进行经验模态分解，产生一组内在的模函数，每一种模态对应一种物理状态，之后使用ＨＴ得出瞬时的频率和振幅，进而得到边际谱(In this paper, is the first of the pulse wave empirical mode decomposition, resulting in a set of intrinsic mode function, each mode corresponds to a physical state, followed by the use of HT derived instantaneous frequency and amplitude, and thus to be marginal spectrum)
- 2009-09-04 10:00:42下载
- 积分：1
