-
xinhaocaiji-
用于振动信号的采集，LABVIEW程序，用于齿轮箱等机械设备的振动故障诊断。(For vibration signal acquisition, LABVIEW program for vibration fault diagnosis of gearboxes and other mechanical equipment.)
- 2012-05-14 16:11:44下载
- 积分：1
-
air-TEST-
基于Labview下 可燃气体浓度监测软件 源码 labview 2010(Based on Labview software under the flammable gas concentration monitoring source labview 2010)
- 2013-09-06 12:47:13下载
- 积分：1
-
多通道数据采集监测系统
说明： 本VI示范了如何通过LabVIEW自身的强大编程能力，开发一套通用的多通道数据采集监测数据库系统。VI包括了主显示界面、用户权限管理、数据采集、超限报警、配置、实时曲线、历史曲线、日志记录、等数据库管理功能。(This VI demonstrates how to develop a common multi-channel data acquisition monitoring database system with LabVIEW's powerful programming capabilities. VI includes the main display interface, user rights management, data collection, overrun alarm, configuration, real-time curve, history curve, log records, and other database management functions.)
- 2017-08-02 10:25:25下载
- 积分：1
-
huiduyuce
使用labview编写的灰色预测程序，判断设备故障的类型，程序已经调试通过。(LabVIEW prepared using gray prediction procedure to determine the type of equipment failure, procedures have been debug through.)
- 2020-12-15 15:29:14下载
- 积分：1
-
hanshuxinhaofashengqi
1．采用Labview设计一虚拟函数信号发生器， 通过数据采集卡输出波形信号，调节信号的相关参数，可观察示波器上波形的变化情况。
⑴ 以NI MyDAQ数据采集卡作为输出接口；
⑵ 数据采集卡输出多种信号，至少完成三种波形：正弦波、三角波、方波(可调占空比)的输出，同时前面板上显示各输出波形；
⑶ 频率、幅值、初相位、直流偏移量和方波的占空比（0～100 ）等参数可以通过前面板控件调节。
⑷ 前面板可显示输出波形。(1. Labview design using a virtual function signal generator, data acquisition card output waveform signal, adjust the relevant parameters of the signal can be observed on an oscilloscope waveform changes.
⑴ with NI MyDAQ data acquisition card as output interface
⑵ data acquisition card output a variety of signals, to complete at least three waveforms: sine wave output, triangle wave, square wave (adjustable duty cycle), while each of the output waveform is displayed on the front panel
⑶ frequency, amplitude, initial phase, the DC offset and duty cycle square wave (0 to 100 ) and other parameters via the front panel controls to adjust.
⑷ output waveform can be displayed on the front panel.)
- 2015-04-25 18:26:52下载
- 积分：1
-
crc32
I was suprised LabVIEW didn t had the CRC32. So I made it, http://en.wikipedia....edundancy_check, http://www.ietf.org/rfc/rfc1952.txt. It can take a array of U32, one element of U32 or a string. When needed I can create more CRC checks, CRC8, CRC16, etc... but CRC32 is the most used one I readed.
- 2014-10-03 08:36:43下载
- 积分：1
-
wljk_labview
labview实现网络摄像头的图像采集，通过TCP/IP协议采集摄像头的图像，这是我在实际监控安防项目中用到的，绝对可以使用。(The LabVIEW realizes the image acquisition of the network camera, and collects the image of the camera through TCP/IP protocol. This is what I used in the actual monitoring and security project. It can be used absolutely.)
- 2020-12-23 17:49:05下载
- 积分：1
-
FreeCOM
labview与串口通信得到串口示波器的波形图(get chart serial port)
- 2016-03-21 09:51:48下载
- 积分：1
-
截图-最前端窗口
说明： 调用dll文件截取最前端窗口的图像，调用需要等待200ms(Calling DLL file to intercept the front-end image)
- 2020-06-24 03:40:02下载
- 积分：1
-
EM9336BD
振动信号采集程序，用于3路信号采集，中泰研创的采集卡程序(Vibration signal acquisition program for 3-channel signal acquisition, the acquisition card program for Research and Innovation and Thailand)
- 2012-12-17 11:09:14下载
- 积分：1
