-
OFDM-based_cellular_mobile_communication_system_Ke
DPD设计的硕士论文，相当的不错！值得收藏！(DPD design master thesis, is pretty good! Worth collecting!)
- 2010-09-03 23:27:21下载
- 积分：1
-
nihefenbu
说明： 拟合各种常见分布程序，产检的威布尔分布，瑞利分布，K分布等分布，采用语言为matlab。(Fitting a variety of common distribution procedures, check-Weibull distribution, Rayleigh distribution, K distribution of the distribution, the use of language matlab.)
- 2011-04-08 21:07:32下载
- 积分：1
-
Rayleigh-Fading-Simulation
rayleigh fading channel matlab codes
- 2013-11-04 05:38:26下载
- 积分：1
-
chengxu
小波变换进行变速箱故障诊断
首先将s1和s2信号时域谱（s1代表维修前的振动信号，s2代表维修后的振动信号），画出来进行对比，会发现s1信号的振动幅值会比较高；然后对s1和s2分别进行小波分解并画出各层的时域谱，只对比s1和s2分后的最高时域谱，s2更加的具有周期性，且幅值较小，s2周期性不够明显，且振动过于密集。分析完时域谱后开始分析频谱，首先对原信号s1和s2fft转换，得到频谱图，如图，然后再对小波分析后高频部分进行fft转换，做出频谱图。对比后我们发现，在f 2375HZ出（也就是齿轮的啮合频率），s1信号频谱幅值会有急剧的升高，然后，其谐波的幅值也会增大。所以可以推断出该维修前的增速箱的齿轮可能出现问题。(Gearbox fault diagnosis based on wavelet transform s1 and s2 first time domain signal spectrum (s1 behalf of the vibration signal before maintenance, vibration signal s2 representative of repaired), drawn comparison, you will find a signal s1 vibration amplitude will be higher then s1 and s2 respectively wavelet decomposition and draw the layers of time-domain spectrum to only a maximum time domain spectroscopy s1 and s2 points after, s2 is more cyclical and smaller magnitude, s2 cyclical enough obviously, and the vibration is too dense. End domain spectral analysis after the beginning of the spectrum analysis, the first of the original signal s1 and s2fft conversion to give the spectrum, as shown, and then after the high frequency part of wavelet analysis fft transformation to make spectrum. We found that after the comparison, at f 2375HZ out (i.e. the gear mesh frequency), there will be a sharp increase in the amplitude spectrum of the signal s1, and then, the amplitude of the ha)
- 2017-01-17 19:18:02下载
- 积分：1
-
FIR_Filter
A 10th order FIR system, excited by a sum of 5 sinusoids. Assume any numeric
values for system coefficients and input signal parameters. The output of the system is
corrupted by Gaussian observation noise with zero mean and variance 2
σ v (consider 2
σ v = 0.1
and 1). The estimator has access to the input and noise corrupted output of the system.
However, the estimator has no knowledge about the system order, its coefficient values and
observation noise variance.
- 2010-10-31 21:53:52下载
- 积分：1
-
emdsource
EMD的处理程序，并且自带了汽轮机组的部分数据，进行验证比较，EMD初学者的入手资料。(EMD handler, and comes with a steam turbine portion of the data, validated comparison, EMD beginners start with item.)
- 2013-09-20 17:25:34下载
- 积分：1
-
Matlab_NI_daq-example
Maltlab DAQ example code
- 2013-04-18 15:06:46下载
- 积分：1
-
123
可以实现自动泊车，采用模糊控制，形象易懂......(Can achieve automatic parking, fuzzy control, image understand ......)
- 2020-07-02 21:20:01下载
- 积分：1
-
bpsk_spread
扩频通信中用bpsk调制的源代码，注释全，简单易懂。(Using spread spectrum modulation bpsk source code, comments all, easy to understand.)
- 2010-06-07 09:22:11下载
- 积分：1
-
specsubm
一个基于dsp的语音降噪算法 (noise reduce)
- 2012-05-14 20:37:25下载
- 积分：1
