登录
首页 » Unix_Linux » RS.WSC.2.0.GENR.2.2.0.1.3.1

RS.WSC.2.0.GENR.2.2.0.1.3.1

于 2013-07-31 发布 文件大小:3761KB
0 129
下载积分: 1 下载次数: 14

代码说明:

  wifi直连模块RS-WC-201的开发固件以及wifi-AP的测试代码。(wifi direct module RS-WC-201' s firmware, and wifi-AP developed the test code.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • STC89C52andX5045
    STC89C52源代码,功能主要包括:看门狗、键盘、数码显示,通信控制。(STC89C52 source code, functions include: watchdog, keyboard, digital display, communication control.)
    2012-08-23 10:23:28下载
    积分:1
  • 基础实验源代码
    测试CC2530,完成基础的功能测试,包括I/O口,串口,无线(Test CC2530, complete the basic functional test, including I/O port, serial port, wireless)
    2018-04-27 10:53:12下载
    积分:1
  • 616343
    取N卡温度源码例程,程序结合易语言系统核心支持库,通过调用dll文件得到N卡当前温度的功能。(Take N card temperature source routines, programs combine core system easy language support library dll file obtained by calling the current function of the temperature N card .)
    2016-12-28 08:49:37下载
    积分:1
  • non-newton
    用于往复运动中的油膜压力分析的非牛顿流体动力润滑程序(Used for reciprocating motion of the oil film pressure analysis of non-newtonian fluid dynamic lubrication)
    2020-09-08 08:38:03下载
    积分:1
  • dc_motor_speed_control_using_8051
    DC motor speed controller
    2018-06-26 23:44:03下载
    积分:1
  • STM32FOC2.0-HALL
    说明:  stm32FOC电机控制程序,使用FOC2.0的库,通过配置后可用于无刷直流电机、永磁同步电机矢量控制(STm32FOC motor control program, using FOC2.0 library, can be used for brushless DC motor, permanent magnet synchronous motor vector control after configuration.)
    2019-03-01 17:00:12下载
    积分:1
  • IIC
    此程序为CRT显示器的IIC总线的驱动,主芯片为MYSON公司的MTV212MN64(This procedure for the CRT display IIC bus driver, the main chip for Myson' s MTV212MN64)
    2009-02-03 15:57:17下载
    积分:1
  • ultrasonic-TCT40-16FS
    说明:  关于利用TCT40-16FS进行超声波测距的原理图,实物图,源码,看完之后对超声波测距将不再陌生.(Conducted on the use of ultrasonic ranging TCT40-16FS schematic, physical map, source, after reading will not be a stranger on the ultrasonic ranging.)
    2011-04-07 11:14:33下载
    积分:1
  • C
    说明:  1.从键盘上输入若干两位十进制数,寻找其中的最小值,然后在屏幕上显示出来. 2.两个十进制数之间的分隔符,输入结束标志自定,但要在报告中说明. 3.对输入要有检错措施,以防止非法字符输入,并有适当的提示. 4.将整个程序分解为若干模块,分别用子程序实现.在报告中要给出模块层次图.(1 Enter a number from the keyboard two decimal digits, to find the lowest value, and then displayed on the screen.           Separator 2. Between two decimal numbers, marks the end of a custom input, but to explain in the report.           3 have error detection on the input measures to prevent the illegal character input, and have the appropriate prompt.           4. The entire program is divided into several modules, each with subroutines in the report to give the module hierarchy diagram.)
    2014-06-16 22:04:49下载
    积分:1
  • AD7714
    stm32和7714之间的SPI调试程序,已经成功可以使用(The SPI debugger between STM32 and 7714 has been successfully used.)
    2020-07-14 14:48:51下载
    积分:1
  • 696518资源总数
  • 105877会员总数
  • 14今日下载