-
DSP的C程序和汇编程序库
说明： 经典DSP的C程序和汇编程序库,有很多实用的程序供大家参考，很有用的！(Classical DSP C language program and assembler language libary. It has many practical programe for all of us. It is very useful.)
- 2005-10-24 10:53:53下载
- 积分：1
-
okumura-hata-model-implementation
OKUMURA-HATA MODEL using MATLAB program.
- 2012-07-17 10:10:43下载
- 积分：1
-
featureSelection
利用保留交叉验证(hold-out)的特征选择，有筛选排序的功能，并最终可以输出对应特征下标。(The use of cross-validation reserved (hold-out) feature selection, there is sort of filtering function, and eventually you can output the corresponding feature subscript.)
- 2013-08-11 10:26:17下载
- 积分：1
-
PQ
说明： 应用于并网的分布式发电或微网系统 PQ控制要求电站的有功和无功是可控的(The distributed power generation or microgrid system PQ control applied to the grid requires that the active and reactive power of the plant is controllable)
- 2017-09-20 19:18:08下载
- 积分：1
-
SRM
project on SRM drive system
The file is a Matlab m-file with all of the input parameters for the two Simulink models and It must be run prior to running the Simulink models to create the input parameters in the Matlab workspace. Because it is a Matlab m-file, it can be opened to change model input parameters. Once you have changed a parameter in you must run it again before you run the Simulink model to update the Matlab workspace and have the change take effect. The file is a Matlab m-file with all of the input parameters for the Simulink model.
- 2013-08-03 08:35:11下载
- 积分：1
-
Link-a-System-Level-OFDM-Simulator
针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator.
Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.
System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.
Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection.
System-level simulator, currently support only SISO and 1 by 2 MRC.
To start with, go into the folder sys_link_simu, and excute the following commond from matlab:
sys_link_simu_func(a,b)
where a is the link ada)
- 2011-08-09 11:00:53下载
- 积分：1
-
EE522_HW3_gyd
FEM solution for microstrip
- 2012-06-26 21:07:54下载
- 积分：1
-
D3squTE
利用有限元法，用comsol和matlab软件计算光子晶体三维带隙(With finite element method, using comsol and matlab software to compute three-dimensional photonic crystals band gap )
- 2011-06-23 10:49:25下载
- 积分：1
-
EZWcode
嵌入式小波零树（EZW）算法的过程详解和Matlab代码。(EZW code 。)
- 2009-04-03 19:12:51下载
- 积分：1
-
a
说明： MATLAB遗传算法几个实例,主要是遗传算法工具箱的应用(some examples of matlab)
- 2009-05-20 18:50:55下载
- 积分：1
