登录
首页 » matlab » robust-control

robust-control

于 2020-08-28 发布 文件大小:420KB
0 88
下载积分: 1 下载次数: 127

代码说明:

  鲁棒控制作业,包含详细的设计报告及matlab仿真代码(Robust control operations, including detailed design reports and matlab simulation code)

文件列表:

鲁棒控制
........\1.1.m,179,2009-08-25
........\1.2.m,317,2009-08-25
........\2.1.m,249,2009-08-24
........\2.2.m,249,2009-08-24
........\2.3.m,241,2009-08-24
........\2.4.m,438,2009-08-24
........\3.1.m,401,2009-08-24
........\3.2.m,469,2009-08-24
........\3.3.m,259,2009-08-24
........\neimo.mdl,10558,2009-08-24
........\鲁棒控制作业.doc,632320,2009-08-27

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • chapter2
    关于 神经网络的matlab程序 的第二章的程序代码(matlab )
    2009-03-09 15:24:49下载
    积分:1
  • chengxu
    小波变换进行变速箱故障诊断 首先将s1和s2信号时域谱(s1代表维修前的振动信号,s2代表维修后的振动信号),画出来进行对比,会发现s1信号的振动幅值会比较高;然后对s1和s2分别进行小波分解并画出各层的时域谱,只对比s1和s2分后的最高时域谱,s2更加的具有周期性,且幅值较小,s2周期性不够明显,且振动过于密集。分析完时域谱后开始分析频谱,首先对原信号s1和s2fft转换,得到频谱图,如图,然后再对小波分析后高频部分进行fft转换,做出频谱图。对比后我们发现,在f 2375HZ出(也就是齿轮的啮合频率),s1信号频谱幅值会有急剧的升高,然后,其谐波的幅值也会增大。所以可以推断出该维修前的增速箱的齿轮可能出现问题。(Gearbox fault diagnosis based on wavelet transform s1 and s2 first time domain signal spectrum (s1 behalf of the vibration signal before maintenance, vibration signal s2 representative of repaired), drawn comparison, you will find a signal s1 vibration amplitude will be higher then s1 and s2 respectively wavelet decomposition and draw the layers of time-domain spectrum to only a maximum time domain spectroscopy s1 and s2 points after, s2 is more cyclical and smaller magnitude, s2 cyclical enough obviously, and the vibration is too dense. End domain spectral analysis after the beginning of the spectrum analysis, the first of the original signal s1 and s2fft conversion to give the spectrum, as shown, and then after the high frequency part of wavelet analysis fft transformation to make spectrum. We found that after the comparison, at f 2375HZ out (i.e. the gear mesh frequency), there will be a sharp increase in the amplitude spectrum of the signal s1, and then, the amplitude of the ha)
    2017-01-17 19:18:02下载
    积分:1
  • Feedbacklinearizacijaulazizlaz
    Feedback linearization of nonlinear multivariable system.
    2010-08-25 03:08:11下载
    积分:1
  • lagrange_basis
    EFG code lagrange for elastic materials
    2021-01-30 01:28:39下载
    积分:1
  • Active-Filters
    This is a simulink program for designing Low pass and High pass ACTIVE Filters circuit.
    2011-10-09 14:08:57下载
    积分:1
  • aloha
    aloha防碰撞基本算法,用matlab仿真。非常好用哦(aloha basic anti-collision algorithm, using matlab simulation. Oh, very easy to use)
    2021-04-23 13:08:47下载
    积分:1
  • Untitled2
    基于DCT的数字水印源码,描述DCT的变换、水印的嵌入过程。(Digital Watermarking Based on DCT source, described in the DCT transform, the watermark embedding process.)
    2009-05-09 09:03:05下载
    积分:1
  • sanweipinpu3
    说明:  用于处理机械动力学响应的三维频谱图matlab程序(Matlab program for the processing of mechanical response to the three-dimensional spectrum)
    2019-03-11 16:43:18下载
    积分:1
  • flower_petal
    一个非常简单而有趣的脚本M文件,用于实现一定的绘图功能(a very simple and interesting script M, used to achieve a certain graphics)
    2005-03-30 10:41:51下载
    积分:1
  • two_d_truss_F06
    2D truss Analysis with matlab
    2010-05-30 03:53:51下载
    积分:1
  • 696524资源总数
  • 103945会员总数
  • 46今日下载