-
ADCRecord
使用STM32F4+usb3300实现虚拟示波器,支持使用外部ADC模式，也就是使用AD9280芯片，最大采样率可达30MSPS.(STM32F4+usb3300 implementation of the virtual oscilloscope, support the use of external ADC mode, that is, the use of AD9280 chip, the maximum sampling rate of up to 30MSPS
)
- 2016-07-04 17:49:34下载
- 积分：1
-
Template
说明： 板载三个灯同时亮灭，板子上可以看到灯发出闪烁的白光(On-board three lights turn on and off at the same time)
- 2020-06-23 14:00:02下载
- 积分：1
-
aduc812
Keil C51编写的Aduc812的完整代码，适合学习使用Aduc812单片机进行AD_da处理
(Keil C51 prepared by the Precise code of integrity, Precise suitable for learning to use the MCU for handling AD_da)
- 2006-08-04 12:48:43下载
- 积分：1
-
KeilC51
这是一本关于Intel 80C51以及广大的51系列单片机的书这本书介绍给读者一些新的技术使你的8051工程和开发过程变得简单请注意这本书的目的可不是教你各种8051嵌入式系统的解决方法(This is a book about the Intel 80C51 microcontroller, and the majority of the 51 books this book introduces readers to some new technology to make your 8051 project and the development process easier, please note that the purpose of this book is not to teach you a variety of 8051 embedded system solution)
- 2010-11-09 20:17:53下载
- 积分：1
-
simpedvr
网上买到的 HI3518 下的 简单DVR CODE, 需要你了解 3518 SDK， 才能编译， (Simple DVR CODE HI3518 under buy online, you need to understand 3518 SDK, you can compile,)
- 2015-11-02 13:54:59下载
- 积分：1
-
12864
ks0108驱动atmea16的；用于proteus仿真使用；可以加载调试其他程序进行显示观测；(ks0108 driver atmea16 for Proteus simulation use can load debugging other programs to display observation )
- 2012-03-07 10:05:37下载
- 积分：1
-
Fisica-Quantica---Lista-03-(Max)
Lista 03 de Fisica Quantica (Max) da Universidade Federal do ABC.
- 2016-07-21 23:25:15下载
- 积分：1
-
jzj-ntc
胶装机控制系统-------c51源代码程序(Plastic installed control system------- c51 source code program)
- 2013-06-19 23:32:19下载
- 积分：1
-
XMEGA_IR_communication_module
Atmel官方红外通信应用参考代码，使用GCC编译器(Atmel reference code official infrared communications applications, using the GCC compiler)
- 2010-09-03 11:30:04下载
- 积分：1
-
pedometer
本文设计了基于加速度传感器的计步器，并通过仿真以及实际调试得到了相应的结果的记录。本实验首先通过加速度传感器检测目标物体的运动，产生脉冲，将脉冲放大后经过施密特触发器整型为方波，并给出了方波的调试电路图。然后编写程序，利用D触发器检测方波的上升沿，当上升沿到来时，计数，并对十位、个位分别编码，然后由使能信号交替控制数码管输出结果。本文给出了仿真以及调试的程序、结果。(This article is designed pedometer-based acceleration sensor and the corresponding results recorded by simulation and debugging. The experiments by first acceleration sensor detects the movement of the target object, generates a pulse, the pulse amplification is a square wave after the Schmitt trigger integer, and gives the the debug circuit diagram of a square wave. Then write procedures, the use of the rising edge of the detection of the square wave of the D flip-flop, when the rising edge, the count, and ten bits are encoded, and then alternately by the enable signal output of the digital control. In this paper, a simulation and debugging procedures, results.)
- 2013-03-13 08:58:22下载
- 积分：1
