-
ch7_2_2
设定循环检测次数,这里设为只循环一次
tip_l=1
设定hough变换的遍历步径
xl=30 %设定线段起始点
xr=60 %设定线段终止点(Set the number of cycle detection, here is set to cycle only once tip_l = 1 set hough transform Path traversal step xl = 30 set line segment starting point xr = 60 set line segment termination point)
- 2007-08-29 19:22:53下载
- 积分:1
-
wimax
this is a small program that I use for some researches
- 2013-02-01 04:58:47下载
- 积分:1
-
wodedmc
一阶纯滞后的DMC控制,单容水箱控制的matlab程序(Order pure lag DMC control, capacity single tank control matlab program)
- 2012-10-10 09:51:49下载
- 积分:1
-
plot_PL_general
一般路径损耗模型分为自由空间传播模型和对数距离路径损耗模型,本程序建立以上模型。(Generally divided into free space path loss model propagation model and logarithmic distance path loss model, the program to build more models.)
- 2014-05-19 15:23:12下载
- 积分:1
-
fftplot
fft and view in matlab
- 2010-05-08 19:07:09下载
- 积分:1
-
A-GMDH-TOOLBOX-FOR-NEURAL-NETWORK-MODELING
A GMDH TOOLBOX FOR NEURAL NETWORK BASED MODELING
- 2014-10-17 04:34:03下载
- 积分:1
-
PCA
主分量分析,用于高维数据降维或提取目标特征。程序精简,效率高.
(Principal Component Analysis is used to make data dimensionality reduction or extract target characteristics。)
- 2010-05-15 22:15:00下载
- 积分:1
-
2D_Holographic
旋转机械二维全息谱计算的实用例程,融合多点信息,提高诊断可靠性。(A good example of two dimension Holographic spectrum calculation of rotational machine,fuse the information of different points to improve the reliability of diagnosis.)
- 2013-02-13 00:24:24下载
- 积分:1
-
CPU315--2-MM420-V3
This program is written to control two inverters MM420 of siemens using PLC s7300
- 2015-02-04 14:57:28下载
- 积分:1
-
三种方法的弹道仿真
matlab/simulink 三种方法的弹道仿真(追踪法、比例导引法、平行接近法) (matlab/simulink Trajectory Simulation of three methods (tracing method, proportional navigation law, parallel close to the law))
- 2021-04-24 11:08:47下载
- 积分:1