-
PID-temperature-control
用组态王做的PID温度控制说明，很简单，很实用(Kingview do with PID temperature control)
- 2020-12-04 14:19:25下载
- 积分：1
-
documents
section network for next generation wireless network
- 2014-02-22 04:13:09下载
- 积分：1
-
clock
本代码是基于标准c8051单片机的时钟打铃程序，主要实现的是数字时钟功能，可对时间进行调整，设定时间定时打铃，并且能随自己意愿调整铃声。(This code is based on the standard c8051 MCU clock bell program, the main achievement is the digital clock feature, which allows time to adjust, set the timer bell time, and can adjust the ring with their wishes.)
- 2012-01-06 14:01:46下载
- 积分：1
-
C51-music
C51 编的音乐程序，关于如何编制音乐代码, 其实十分简单，频率常数即音乐术语中的音调,而节拍常数即音乐术语中的多少拍(C51 music program)
- 2013-12-22 13:47:44下载
- 积分：1
-
14.AD和DA
直接使用开发板上自带的ADDA功能，稳定可靠(The direct use of the development board comes with the ADDA function, stable and reliable)
- 2017-09-17 07:20:09下载
- 积分：1
-
I2C
iic接口的程序，可以用于f149单片机(iic interface procedures can be used F149 microcontroller)
- 2013-05-21 09:14:51下载
- 积分：1
-
stm32 直流电机编码器
stm32直流电机电机编码器 定时器编码器模式(timer encoder mode........)
- 2020-06-19 06:40:02下载
- 积分：1
-
T3T4
c8051f，t3产生方波，t4计数自动重载，在计数应用使用率比较高，简单代码，稍加修改即可将其加入自己的代码(c8051f060 T3 configuring as Mode1,T4 Auto-Reload Mode)
- 2010-06-05 17:09:41下载
- 积分：1
-
GP2D12
利用PROTEUS,在C51单片机上,利用GP2D12测距传感器进行红外线测距的仿真,亲测可用.(Use of PROTEUS, the C51 microcontroller, using GP2D12 infrared distance sensors ranging simulation, pro-test is available.)
- 2013-06-12 14:13:36下载
- 积分：1
-
FreeRTOS实验15-1 FreeRTOS软件定时器实验
硬件资源:
1,DS0(连接在PA8)，DS1(连接在PD2上)
2,串口1(波特率:115200,PA9/PA10连接在板载USB转串口芯片CH340上面)
3,ALIENTEK 2.8/3.5/4.3寸LCD模块(仅支持MCU屏)
4,按键KEY0(PC5)/KEY1(PA15)/KEY_UP(PA0,也称之为WK_UP)
实验现象:
通过按键KEY_UP可以控制定时器AutoReloadTimer_Handle的开启，这个是
周期定时器，一旦开启就会不断的运行，直到按下KEY1将其关闭。按下KEY0
可以打开定时器OneShotTimer_Handle，这是个单次定时器，只会运行一次，
运行周期到了以后就会停止运行，除非按下按键KEY0将其再次开启。(Hardware resources:
1, DS0 (connected to PA8), DS1 (connected to PD2)
2. Serial port 1 (baud rate: 115200, PA9/PA10 connected on board USB to serial chip CH340)
3, ALIENTEK 2.8/3.5/4.3 inch LCD module (only supporting MCU screen)
4. Keyboard KEY0 (PC5)/KEY1 (PA15)/KEY_UP (PA0, also known as WK_UP)
Experimental phenomena:
The timer AutoReloadTimer_Handle can be turned on by keying KEY_UP. This is
The periodic timer will run continuously once it is turned on until KEY1 is pressed to turn it off. Press KEY0
You can turn on the timer OneShotTimer_Handle, which is a single timer and only runs once.
The run cycle will stop after that unless KEY0 is pressed to turn it on again.)
- 2020-06-24 05:00:01下载
- 积分：1
|
联系客服（QQ：3324461878）
