登录
首页 » PDF » Discrete-Optimization-in-Early-Vision

Discrete-Optimization-in-Early-Vision

于 2013-09-19 发布 文件大小:15063KB
0 187
下载积分: 1 下载次数: 1

代码说明:

  This thesis describes methods for solving certain optimization problems commonly arising in computer vision by PETTER STRANDMARK

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • amtf
    matlab仿真源代码,AM源程序,用matlab运行(matlab simulation source code, AM source, using matlab to run)
    2008-05-20 16:42:42下载
    积分:1
  • chapter03
    说明:  无线通信中的天线仿真,matlab平台上提供源码,第二部分(Wireless communication antenna simulation, matlab source platform, Part II)
    2008-11-26 18:01:46下载
    积分:1
  • trns
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:45:44下载
    积分:1
  • PCA09DEMO
    PROGRAM OF PRINCIPAL COMPOSANTE
    2014-12-01 06:17:16下载
    积分:1
  • zhouchen
    小波阈值自动选取方案去噪,并用HHT对去噪后的轴承信号进行处理,提取故障特征。(Wavelet threshold de-noising program automatically chooses, for bearing with HHT denoised signal processing, fault features.)
    2021-04-13 22:18:55下载
    积分:1
  • integerandquadratic
    整数规划(Integer programming)分支定界法 二次规划(quadratic programming)路径跟踪法(Integer programming (Integer programming)branch and bound method quadratic programming (quadratic programming)the path tracing method)
    2009-11-04 09:26:25下载
    积分:1
  • B2
    说明:  若锗中含有一定数量的杂质元素Sb,试根据要求分析杂质浓度与电离度以及电离温度之间的关系: (1)当Sb浓度分别为 和 时,计算杂质99%,90%和50%电离时的温度各为多少? (2)根据一定杂质类型和杂质浓度,画出电离度和温度的关系图线,并确定半导体处于强电离区(电离度>90%)的温度范围。 设计要求:(1)具有友好输入输出界面; (2)调整输入数据,得出相应结果,并进行分析。 (If the germanium containing a certain number of impurity elements Sb, test analysis in accordance with the requirements of impurity concentration and ionization degree, as well as the relationship between the ionization temperature: (1) When the Sb concentration and time were calculated 99 percent of impurities, 90 and 50 ionization When the temperature of each number? (2) according to certain types of impurities and impurity concentration, ionization degree and temperature to draw the relationship between the graph lines, and to determine the semiconductor in a strong ionization zone (ionization degree)
    2008-07-16 19:57:43下载
    积分:1
  • mlr1
    mlr codes in matla is very good anduseful to usein mTLAB
    2009-11-03 15:44:58下载
    积分:1
  • convolution_code
    移动通信系统中,卷积码的matlab仿真程序(Convolutional code matlab simulation program)
    2013-11-01 15:17:24下载
    积分:1
  • squarecoax
    this program, is written in Matlab code by FDTD metod and calculates the capacity of a SQUARE COAXIAL cable.
    2011-06-16 23:17:51下载
    积分:1
  • 696516资源总数
  • 106562会员总数
  • 4今日下载