-
Matlab-Example
MTi-G 微机械陀螺仪自带matlab源码(MTi-G the micromachined gyroscopes comes matlab source)
- 2013-01-22 12:55:33下载
- 积分:1
-
Count-24-points
算24点的程序,Matlab下使用,比赛主办方提供的参考资料,完全可以使用.(Count 24 point program, Matlab is used, the game organizers to provide reference materials can be used.)
- 2013-08-14 20:57:02下载
- 积分:1
-
Project_4_haze-removal
haze removal code using matlab . software based taken a research paper
- 2014-11-12 15:52:32下载
- 积分:1
-
DTCsix_torque
直接转矩控制(DTC)Matlab仿真文件(Direct Torque Control (DTC) Matlab simulation file)
- 2013-10-21 10:48:31下载
- 积分:1
-
cesuyi
车辆监测用测速雷达是依据多普勒效应原理实现的。由雷达发出一束微波,遇被测目标(车辆)时微波被反射回来,再由雷达接收反射波。如果目标相对于雷达有距离上的运动,反射波的频率将与发射频率发生差异,而这种差异的大小正比于目标与雷达的相对运动速度。于是,雷达通过检测反射波频率和发射波频率的差,就可以计算出被测车辆的移动速度。本次课程设计是利用离散付里叶变换进行频谱分析,设计数字滤波器组,并对滤波器组加窗降低副瓣,通过频域方法测量速度。(Vehicle monitoring using radar gun is based on the realization of the principle of the Doppler effect. By the radar emits a microwave, in case the measured target (vehicle) when the microwave is reflected back, and then by receiving the reflected radar waves. If the target relative to the radar on a distance of motion, the frequency of the reflected wave and the emission frequency of the difference, and this difference is proportional to the relative target and radar velocity. Thus, by detecting the reflected radar wave frequency and the frequency difference between the transmitted wave, we can calculate the movement speed of the vehicle under test. This course is designed to take advantage of the discrete Fourier transform spectral analysis, digital filter design group, and filter bank windowed lower sidelobes by frequency domain methods to measure speed.)
- 2013-05-26 13:26:15下载
- 积分:1
-
汽车空调温度simulink模型
说明: 汽车空调温度simulink模型,描述汽车空调系统控制原理(atecontrol_for_vehicle)
- 2019-01-29 21:41:40下载
- 积分:1
-
EZWcode
嵌入式小波零树(EZW)算法的过程详解和Matlab代码。(EZW code 。)
- 2009-04-03 19:12:51下载
- 积分:1
-
matlab
gps卫星中利用精密星历文件提供的钟差信息没差出任意时刻的钟差值(gps satellite ephemeris file using precision clock error information provided at any time without deviation from the clock difference)
- 2011-04-22 13:19:55下载
- 积分:1
-
buckPWM
There are three kinds of switching mode DC-DC converters, buck, boost and buck-boost. The buck mode is used to reduce output voltage, whilst the boost mode can increase the output voltage. In the buck-boost mode, the output voltage can be maintained either higher or lower than the source but in the opposite polarity.
- 2012-07-07 14:28:58下载
- 积分:1
-
fuzzy_pid
模糊pid参数自整定 matlab仿真m文件(fuzzy-pid matlab )
- 2013-03-12 09:38:20下载
- 积分:1