-
dianliu
散射电流仿真、可视化、c++和matlab(Scattering current simulation、visualization、c++and matlab
)
- 2012-03-30 10:56:36下载
- 积分：1
-
Fading-Modeling-in-MATLAB
Mobile Radio Channels Modeling in MATLAB
- 2013-01-09 21:40:06下载
- 积分：1
-
lms
LMS算法的仿真程序，对比mu不同时的收敛速率(LMS algorithm simulation program, while comparing the convergence rate is not mu)
- 2010-06-19 03:58:52下载
- 积分：1
-
shuzi
基带信号周期采样的分析与仿真设计低通信号，对该信号进行周期采样，最后从采样数据中恢复原始信号；改变采样频率，给出相应的仿真结果；考察前端抗混叠滤波器的作用和必要性；分析后端理想恢复滤波器是否唯一。(
Periodic sampling of the baseband signal analysis and simulation to design low pass signal, the signal is periodic sampling, finally recover the original signal from the sampled data changing the sampling frequency, gives the corresponding simulation results examine the front of the role of anti-aliasing filter and necessity analysis backend ideal restoration filter is unique.)
- 2013-11-23 15:46:45下载
- 积分：1
-
Tamirin_2_2
dielectric waveguide
optiwave simulation
- 2015-01-29 17:47:07下载
- 积分：1
-
AES1
testing advanced encryption system in matlab with multiple .m file already tested and well working under any of mathlab versions new or older.
- 2011-05-22 17:08:39下载
- 积分：1
-
danyonghu
单用户超宽带通信系统仿真,基于线性调频信号(single-user UWB communication system simulation, based on the linear FM signal)
- 2007-01-10 13:25:52下载
- 积分：1
-
New-folder
resampling program in matlab
- 2013-09-10 19:04:01下载
- 积分：1
-
PID-MATLAB
先进PID控制MATLAB仿真（第二版）程式
光盘使用说明
1、所有仿真算法按章归类，光盘中的程序名与书中一一对应。
2、将光盘中的仿真程序复制到硬盘MATLAB运行的路径中，便可仿真运行。
3、本书算法在MATLAB 5.3版下运行成功，并适用于其他版本。
4、程序chap1_11.mdl；chap3_2.mdl；chap3_5.mdl；chap6_2.mdl；chap6_4.mdl需要在Matlab6.5下运行，特此说明。
5、假如您对仿真程序有疑问，请及时通过 E-mail 与作者联系。
北京航空航天大学 刘金琨
E-mail 地址： ljk@dept3.buaa.edu.cn或ljk@buaa.edu.cn
- 2015-01-09 20:36:21下载
- 积分：1
-
OFDM-basedWirelessBroadBandSystemSimulator
基于OFDM的无线宽带系统仿真It contains mainly two parts, i.e. link-level simulator and system-level simulator.
Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.
System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.(OFDM-based wireless broadband system simulation It contains mainly two parts, ie link-level simulator and system-level simulator.Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx . Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.System- level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.)
- 2008-01-05 00:08:29下载
- 积分：1
|
联系客服（QQ：3324461878）
