-
chengjidengji
给出百分制成绩，要求输出成绩等级，90分及以上为A，80分至89分为B，70分至79分为C，60至69分为D，59分及以下为E，小于0分或者高于100分弹出错误提示框。(Given percentile scores, the required output Grade, 90 points and above for A, 80 to 89 are divided into B divided into C, 70 to 79, 60 to 69 is divided into D 59 and for E < 0 or higher than 100 pop-up error message box.)
- 2020-11-03 23:39:52下载
- 积分：1
-
signal_001
信号发生器，带扫频，带频率的切换！最小可以0.1HZ。(Frequency sweep signal generator, belt, belt frequency switch! Minimum to 0.1 HZ.)
- 2013-06-30 09:03:01下载
- 积分：1
-
Labview Call Matlab 测试Labview调用Matlab脚本
说明： Labview Call Matlab 测试Labview调用Matlab脚本(Labview Call Matlab Test Labview to call Matlab script)
- 2019-10-24 09:32:15下载
- 积分：1
-
LabVIEW-bao-dian
Labview宝典课件，非常适合初学者学习的一点即通的学习资料(Labview Collection courseware, very suitable for beginners to learn the point that through the learning materials)
- 2013-08-17 11:33:12下载
- 积分：1
-
labview
使用电脑自带声卡在labview中实现录音播放(With labview achieve Recording Playback)
- 2020-12-31 21:28:58下载
- 积分：1
-
TCP IP客户端
输控制协议（TCP，Transmission Control Protocol）是一种面向连接的、可靠的、基于字节流的传输层通信协议，由IETF的RFC 793定义。TCP旨在适应支持多网络应用的分层协议层次结构。(Transmission Control Protocol (TCP) is a connection-oriented, reliable, byte-stream-based transport layer communication protocol defined by IETF RFC 793. TCP aims at adapting to the hierarchical protocol structure supporting multi-network applications.)
- 2020-06-18 11:00:01下载
- 积分：1
-
数据采集编程指南 中篇
NI DAQ应用介绍
1. 一个完整数据采集系统的基本组成部分
2. NI 提供了基于哪些平台的数据采集硬件产品，它们分别适用于什么样的应用领域
3. 数据采集设备硬件选型过程中应该关注哪些重要参数(Introduction of NI data acquisition hardware 1. Basic components of a complete data acquisition system 2. NI provides data acquisition hardware products based on which platforms and which application areas they are suitable for respectively. 3. What important parameters should be paid attention to in the process of hardware selection of data acquisition equipment)
- 2020-06-21 20:20:01下载
- 积分：1
-
labview-capacity
labview vi程序，基于版本8.2可以直接运行，,用来仿真电容充放电过程(labview vi program, based on version 8.2 can be run directly, to simulate capacitor charging and discharging process)
- 2013-08-03 12:04:12下载
- 积分：1
-
拉力传感器电机控制
数据采集卡采集拉力值，与预先设定的拉力值进行比较，然后PID运算，控制相应的PWM占空比输出，最终控制电机的速度(The data acquisition card collects the pull value and compares it with the pre-set pull value. Then the PID arithmetic is used to control the output of the corresponding PWM duty cycle, and finally the speed of the motor is controlled.)
- 2020-06-17 02:00:01下载
- 积分：1
-
tdm example
用MATLAB读取labview监测到到数据波形(Read the data and waveform monitored by LabVIEW with MATLAB)
- 2018-05-20 22:43:11下载
- 积分：1
