登录
首页 » Visual Basic » jianpansaomiao

jianpansaomiao

于 2013-09-29 发布 文件大小:26KB
0 191
下载积分: 1 下载次数: 1

代码说明:

  对矩阵键盘的程序编写,详细地讲述了如何扫描键盘的输入!(The matrix keyboard programming, detailed tells the story of how to scan the keyboard input!)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • main
    EDA课程设计抢答器的程序,将程序加入仿真电路可直接运行出结果(EDA course design responder programs, add the program simulation circuit can be run directly the results )
    2015-05-21 20:28:37下载
    积分:1
  • analog-I2C-driver-MPU050
    stm32芯片--用GPIO口模拟I2C驱动MPU6050陀螺仪(Stm32 chip- using GPIO port simulation I2C driver MPU6050 gyroscope)
    2013-12-19 19:43:04下载
    积分:1
  • bldc-drive-with-hall
    基于stm32的bldc驱动,有hall位置传感器,电流传感器采样,方波驱动。(Based on stm32 BLDC drive motors, hall position sensor, current sensor sampling, square wave drive.)
    2020-10-10 22:07:40下载
    积分:1
  • led
    51单片机的led灯亮的c语言 程序使其旋转形成圆形(five one single chip microcomputer)
    2011-12-26 09:45:59下载
    积分:1
  • fer1
    $regfile = M8DEF.dat internal crystal 8000000 Config Lcdpin = Pin , Db4 = Portc.1 , Db5 = Portc.2 , Db6 = Portc.3 , Db7 = _ Portc.4 , E = Portd.2 , Rs = Portd.3 Config Lcd = 16 * 2 Config Timer1 = Counter , Edge = Rising Ddrb.1 = 0 : Portb.1 = 1 PULL UP RESISTOR ACTIVATED Config Timer0 = Timer , Prescale = 1024 Enable Counter1 Enable Interrupts Enable Timer0 Enable Timer1 On Ovf1 Pulsecount On Ovf0 Ovf0occures Dim A As Long , I As Long , B As Byte B = 0 Cls Start Timer0 Do Loop End end program Ovf0occures: Incr I If I > 30 Then Stop Timer0 Cls : Home A = B * 65536 A = A + Counter1 Lcd FREQ IS : A HZ B = 0 I = 0 : Counter1 = 0 Start Timer0 End If Return Pulsecount: Incr B Counter1 = 0 Return
    2014-11-22 01:04:48下载
    积分:1
  • Building-of-a-Speech-Corpus-Optimised-for-Unit-Se
    The paper deals with the process of designing a phonetically and prosodically rich speech corpus for unit selection speech synthesis. The attention is given mainly to the recording and verification stage of the process.
    2014-03-01 22:14:41下载
    积分:1
  • kuanfang-
    以dac7811带动的宽放的编写程序, 以dac7811带动的宽放的编写程序 以dac7811带动的宽放的编写程序,,(In dac7811 driven liberalization of programmingIn dac7811 driven liberalization of programming)
    2013-09-04 08:26:14下载
    积分:1
  • cheng
    滤波器广泛应用于数字信号处理、通信、自动控制领域,但设计可变宽频带有源滤波器则比较困难。利用单片机控制参数可编程的双二阶通用开关电容有源滤波器,精确设置有源滤波器的中心频率f,品质因数Q及有源滤波器的工作方式。本系统主要分为两个部分:即程控滤波器和程控放大器。程控放大器电压增益为40dB,通过单片机控制DA进行分压,可精确实现要求的10dB步进,误差小于0.5 ,通带为100Hz-500KHz,输入电压峰-峰值范围为10mV,在输入范围内无明显失真。由MAX264为核心的滤波器,可设置为高通、低通滤波器。通过单片机直接给出控制频率,使-3dB截止频率在1KHz-20KHz内可调,步进1KHz,误差小于1 。整个系统以52单片机为控制核心,电路简单,性能稳定,且具有较高精度,滤波参数调节通过单片机控制,较为方便。(Filters are widely used in digital signal processing, communications, automatic control area, but the design variable wideband active filter is more difficult. Control parameters using single-chip programmable universal switched-capacitor biquad active filter, active filter accurately set the center frequency f, quality factor Q and the active filter works. The system is mainly divided into two parts: the program-controlled filters and programmable amplifiers. Programmable amplifier voltage gain of 40dB, the DA through the partial pressure of single-chip control, can accurately achieve the required 10dB step, the error is less than 0.5 , passband to 100Hz-500KHz, input voltage peak- the range of 10mV, the input range no significant distortion. By the MAX264 as the core of filter can be set to high pass, low pass filter. Given directly by the microcontroller controls the frequency, the-3dB cutoff frequency at 1KHz-20KHz adjustable, step 1KHz, error is less than 1 . The entire system for)
    2011-07-17 16:23:27下载
    积分:1
  • parker
    基于美国PARKER运动控制器开发的多轴运动控制界面,包括直线,圆弧插补等,界面友好,直观(PARKER motion controller based on U.S. developed multi-axis motion control interface, including linear and circular interpolation, etc., user-friendly, intuitive)
    2020-09-10 06:38:00下载
    积分:1
  • measured-frequency-meter
    51单片机测频计 可测1M赫兹一下的方波 有很多不恰当的地方 往海涵 自己敲的代码 新手。。。(The 51 MCU measured frequency meter)
    2012-12-08 21:25:06下载
    积分:1
  • 696518资源总数
  • 106155会员总数
  • 8今日下载