-
tftb2002toolbox
matlab时频分析数据包，用于信号分析处理(matlab time-frequency analysis data packets for signal analysis and processing)
- 2013-04-19 16:15:09下载
- 积分：1
-
cyclic-test
matlab编程的循环统计量的仿真程序，运行了效果还行，可能有些地方不太好，敬请指正(matlab programming cycle statistics of the simulation program, run the results were OK, there may be some places not very good, please correct me)
- 2011-09-10 22:34:02下载
- 积分：1
-
ACO-for-TSP
tsp aco algorithm with simulation
- 2012-07-18 18:54:46下载
- 积分：1
-
Shape-context1
说明： 自己整理的关于shape context。有matlab代码和word文档，word文档是关于shape context原理的介绍。相当全面。(Their order on the shape context. A matlab code and word document, word document is an introduction on the principles of shape context. Quite comprehensive.)
- 2011-03-05 09:29:35下载
- 积分：1
-
image-compression-based-svd
使用matlab，用于基于奇异值分解（SVD）的图像压缩(image compression based on Singular value decomposition (SVD))
- 2015-04-14 23:06:53下载
- 积分：1
-
WTE
六个信号的小波时间熵进行比较，在同一图上画出六信号波形(Six wavelet entropy to compare the time in the same graph draw the six signal waveforms)
- 2008-01-15 11:29:45下载
- 积分：1
-
BPyuce
觉得很好的一个Matlab论文想和大家一起分享，互相学习。(Find a good paper would like Matlab to share with everyone, learn from each other.)
- 2010-12-09 17:08:02下载
- 积分：1
-
FinancialOptimizationusingMATLABFinancialToolbox
对于Matlab的金融工具箱的更为优化使用。类似与指导书尤其关于使用技巧指导。(Financial Optimization using MATLAB’s Financial Toolbox
Sonal Varshney, Arnab Sarkar
)
- 2010-12-31 10:37:41下载
- 积分：1
-
遗传算法求解TSP问题
说明： 基本遗传算法求解TSP问题，只需给出城市间距离矩阵和初始参数即可进行计算。(basic genetic algorithm for TSP, is only inter-city distance matrix and the initial parameters can be calculated.)
- 2005-11-16 20:24:30下载
- 积分：1
-
Link-a-System-Level-OFDM-Simulator
针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator.
Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.
System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.
Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection.
System-level simulator, currently support only SISO and 1 by 2 MRC.
To start with, go into the folder sys_link_simu, and excute the following commond from matlab:
sys_link_simu_func(a,b)
where a is the link ada)
- 2011-08-09 11:00:53下载
- 积分：1
