登录
首页 » Others » UltrasonicTesting

UltrasonicTesting

于 2014-10-31 发布 文件大小:6157KB
0 170
下载积分: 1 下载次数: 4

代码说明:

  这是一本超声波2级考证的一本书,也是超声波专业学习者和研究者的基础书籍,很实用的。(This is a book about the ultrasonic level 2, and it is also the basis of learners of ultrasonic professional and researchers books, very practical.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • MODBUS
    说明:  基于MODBUS协议的单片机通信系统,上位机+下位机(MODBUS Protocol-based communication system microcontroller)
    2011-03-28 10:17:22下载
    积分:1
  • luojinmenyu
    这是一个楼禁门宇系统的程序,经过调试仿真,结果良好,但是有待改进(This is a building ban door-yu system procedures, after debugging emulator with good results, but could be improved)
    2013-09-24 20:10:23下载
    积分:1
  • runclock
    这是一个51单片机小程序,功能是实现跑马表,只有三位。(This is a small program the microcontroller 51, the table function is to achieve the Happy Valley, only three.)
    2011-12-01 20:02:04下载
    积分:1
  • sfs
    sfs shape from shading由阴影到形状 tsai 的三篇论文以及代码,试验用图片。(sfs shape from shading)
    2014-08-04 16:02:07下载
    积分:1
  • freemodbus-v1.5.0
    说明:  freemodbus-v1.5.0无改动官方源码,可移植(Freemodbus-v1.5.0 Portable without changing official source code)
    2020-06-18 00:00:01下载
    积分:1
  • G2232
    动力电池保护板程序,包括主程序,IIC,定时器,ADC(Power battery protection board procedures, including the main program, IIC, timer, ADC)
    2012-11-26 21:26:14下载
    积分:1
  • 115242424
    设计一个十字路口的交通灯控制电路,要求东西方向车道和南北方向车道两条交叉道路上的车辆交替运行,每次通行时间都设为45秒。时间可设置修改。(Design a crossroads of traffic lights control circuit requires lane east-west direction and north-south direction of the two-lane cross-road vehicles to run alternately, each opening hours are set to 45 seconds. Time can be set to amend.)
    2020-12-24 12:09:05下载
    积分:1
  • stm32(示波器)8.7
    说明:  STM32示波器c语言程序,欢迎下载,谢谢(STM32 viewer C language)
    2020-06-23 11:00:02下载
    积分:1
  • avr_com
    //实验板的AVR程序,uart应用,和计算机通讯,回送PC发送的数据 //接线定义:PD0-RXD PD1-TXD 开关位置:SW6-7/8打开。 //使用串口调试器,使用十六进制方式,首先让PC发送一个字符给MCU,然后将接收到MCU返回的值。 //记事:本程序旨在对uart的理解与演示,程序适合初学者使用. //使用片外8MHz晶体,9600bps波特率(//Experimental board AVR procedures, uart applications, and computer communications, PC loopback send data// connection definition: PD0-RXD PD1-TXD switch location: SW6-7/8 open.// Use the serial port debugger, use the hexadecimal mode, let PC send a character to the MCU, and then will receive the MCU to return value.// Note: This program seeks to UART understanding and demonstration of procedures suitable for beginners to use.// Use the chip 8MHz crystal, 9600bps baud rate)
    2007-10-26 20:41:31下载
    积分:1
  • i2c_ee
    此编成是使用STM32 的DMA读取写入EEPROM内的资料(STM32 DMA read and write EEPROM)
    2018-08-02 18:41:54下载
    积分:1
  • 696516资源总数
  • 106923会员总数
  • 0今日下载